动力工程学报
動力工程學報
동력공정학보
JOURNAL OF POWER ENGINEERING
2012年
7期
558-561,568
,共5页
陈海平%王忠平%吴文浩%童家麟
陳海平%王忠平%吳文浩%童傢麟
진해평%왕충평%오문호%동가린
CO2捕捉%循环煅烧/碳酸化法%过程模拟%余热利用%灵敏度分析
CO2捕捉%循環煅燒/碳痠化法%過程模擬%餘熱利用%靈敏度分析
CO2포착%순배단소/탄산화법%과정모의%여열이용%령민도분석
CO2 capture%CCRs%process simulation%waste heat utilization%sensitivity analysis
采用商业软件AspenPlus对钙基吸收剂循环煅烧/碳酸化法(CCRs)的碳捕捉过程进行了模拟,讨论CCRs碳捕捉系统的能量回收问题,并运用AspenPlus软件进行灵敏度分析,研究补充碳酸钙流量对循环固体量、煅烧燃煤量和CO2捕捉率的影响.结果表明:某600Mw超临界机组引入CCRs碳捕捉系统后,机组效率下降为39.599/6,而将该碳捕捉系统回收的能量用于蒸汽轮机发电,电厂输出功率则从600MW增加到1041.90Mw.
採用商業軟件AspenPlus對鈣基吸收劑循環煅燒/碳痠化法(CCRs)的碳捕捉過程進行瞭模擬,討論CCRs碳捕捉繫統的能量迴收問題,併運用AspenPlus軟件進行靈敏度分析,研究補充碳痠鈣流量對循環固體量、煅燒燃煤量和CO2捕捉率的影響.結果錶明:某600Mw超臨界機組引入CCRs碳捕捉繫統後,機組效率下降為39.599/6,而將該碳捕捉繫統迴收的能量用于蒸汽輪機髮電,電廠輸齣功率則從600MW增加到1041.90Mw.
채용상업연건AspenPlus대개기흡수제순배단소/탄산화법(CCRs)적탄포착과정진행료모의,토론CCRs탄포착계통적능량회수문제,병운용AspenPlus연건진행령민도분석,연구보충탄산개류량대순배고체량、단소연매량화CO2포착솔적영향.결과표명:모600Mw초림계궤조인입CCRs탄포착계통후,궤조효솔하강위39.599/6,이장해탄포착계통회수적능량용우증기륜궤발전,전엄수출공솔칙종600MW증가도1041.90Mw.
The multiple cyclic calcination/carbonation reactions (CCRs) process for CO2 capture has been simulated using commercial software Aspen Plus, with focus on the energy recovery of the CCRs system, while an analysis performed on the sensitivity of simulated results, so as to analyze the effect of the mass flow of make-up CaCO3 on the solids circulation rate, the coal consumption for carbonation process and the CO2 capture rate. Results show that after the introduction of CCRs system to a 600 MW supercritical power plant, the unit efficiency drops to 39.59%, but the plant power output rises from 600 MW to 1 041.90 MW, due to additional power generation by steam turbine with the energy recovered by CCRs system.