CAJ | 학술논문

研究了注塑机锁模机构伺服驱动器的技术,提出了一种基于DSP的全电动注塑机运动伺服控制器的设计思路。针对注塑工艺设计伺服电机控制器具有功能简化、成本降低等优点。本文通过对合模机构的伺服运动控制的研究,可以起到举一反三的效果,把伺服控制器的设计思想推广到射胶、熔胶等机构。伺服控制器的研究主要是针对交流永磁同步电机,也研究了廉价的无刷直流电机在全电动注塑机上的应用。
연구료주소궤쇄모궤구사복구동기적기술,제출료일충기우DSP적전전동주소궤운동사복공제기적설계사로。침대주소공예설계사복전궤공제기구유공능간화、성본강저등우점。본문통과대합모궤구적사복운동공제적연구,가이기도거일반삼적효과,파사복공제기적설계사상추엄도사효、용효등궤구。사복공제기적연구주요시침대교류영자동보전궤,야연구료렴개적무쇄직류전궤재전전동주소궤상적응용。
All -electric injection molding clamping mechanism technology was introduced. The research focused on the motor controller technology, as the lower controller of the whole controlling system. The servo motor controller solution was based on DSP. By researching the principle of clamping mechanism, the servo controller design can be extended to the other electric driven mechanism. The research was mainly based on PMSM. For the sake of motor cost, the application posibility of BLDCM was aslo studied.