矿业工程研究
礦業工程研究
광업공정연구
MINERAL ENGINEEERING RESEACH
2012年
2期
15-19
,共5页
近距离%特厚煤层%覆岩破坏%相似模拟%一次采全高
近距離%特厚煤層%覆巖破壞%相似模擬%一次採全高
근거리%특후매층%복암파배%상사모의%일차채전고
close distance%extra thick coal seam%overburden failure%analog simulation%once mining methods
根据潘谢矿区地质条件及采取一次采全高开采方式,采用物理相似模拟实验方法,对近距离特厚煤层开采时覆岩破坏及位移特征进行了分析,得出了随着覆岩的采动垮落、裂隙高度的增加和范围的增大,形成了阶梯跳跃式趋于稳定,并且确定了近距离特厚煤层一次采全高垮落带及其裂隙带的发育高度.随工作面的推进,层间岩层形成明显的移动变形盆地,同一岩层中下沉移动量最大的点位基本处于下部采空区中心上方.由于采高较大,应力集中沿工作面推进方向不断延伸扩展,应力集中系数较分层开采要小,但前方影响范围要大.
根據潘謝礦區地質條件及採取一次採全高開採方式,採用物理相似模擬實驗方法,對近距離特厚煤層開採時覆巖破壞及位移特徵進行瞭分析,得齣瞭隨著覆巖的採動垮落、裂隙高度的增加和範圍的增大,形成瞭階梯跳躍式趨于穩定,併且確定瞭近距離特厚煤層一次採全高垮落帶及其裂隙帶的髮育高度.隨工作麵的推進,層間巖層形成明顯的移動變形盆地,同一巖層中下沉移動量最大的點位基本處于下部採空區中心上方.由于採高較大,應力集中沿工作麵推進方嚮不斷延伸擴展,應力集中繫數較分層開採要小,但前方影響範圍要大.
근거반사광구지질조건급채취일차채전고개채방식,채용물리상사모의실험방법,대근거리특후매층개채시복암파배급위이특정진행료분석,득출료수착복암적채동과락、렬극고도적증가화범위적증대,형성료계제도약식추우은정,병차학정료근거리특후매층일차채전고과락대급기렬극대적발육고도.수공작면적추진,층간암층형성명현적이동변형분지,동일암층중하침이동량최대적점위기본처우하부채공구중심상방.유우채고교대,응력집중연공작면추진방향불단연신확전,응력집중계수교분층개채요소,단전방영향범위요대.
Taking once mining methods and employing physical similarity simulation method according to the Panxie mine geological conditions, this paper further analyzes the characteristics of destruction and displacement of the overlying strata in the close - thick coal seam mining, with the dynamic collapse fall of overlying rock mining and the increase of fracture height and the range, forming the ladder by leaps and bounding to become stable, which determines the close - thick coal seam mining of full - height growth height of caving with fractured zone. With the advance of the face layer between the rock formation of significant movement and deformation of the basin, the amount of movement points are basically at the top of the lower part of the goaf center in the sink in the same rock. Due to the higher cutting height, the stress concentration extended along the working face advancing direction and the stress concentration factor is smaller compared with layered mining, but is larger of area of effect.