电子工业专用设备
電子工業專用設備
전자공업전용설비
EQUIPMENT FOR ELECTRONIC PRODUCTS MANUFACTURING
2012年
9期
27-30
,共4页
炉内传热%ANSYS%热分析
爐內傳熱%ANSYS%熱分析
로내전열%ANSYS%열분석
Furnace heat transfer%ANSYS%Thermal Analysis%FEA
根据某型电阻炉炉膛组件结构和实际测试数据,采用ANSYS有限元分析软件建立一种炉膛简化二维模型。并对实测炉膛内温度数据分析计算,由此获得炉膛内壁综合换热系数,将其作为边界条件施加在模型中,进行稳定态分析。通过分析仿真实验获得的炉膛组件截面温度梯度分布,温度分布曲线和网格节点温度矩阵,对比实际工况,可知仿真实验结果正确可靠。该简化模型及分析方法可以用作验证和模拟实验,来指导产品设计,优化炉膛结构。
根據某型電阻爐爐膛組件結構和實際測試數據,採用ANSYS有限元分析軟件建立一種爐膛簡化二維模型。併對實測爐膛內溫度數據分析計算,由此穫得爐膛內壁綜閤換熱繫數,將其作為邊界條件施加在模型中,進行穩定態分析。通過分析倣真實驗穫得的爐膛組件截麵溫度梯度分佈,溫度分佈麯線和網格節點溫度矩陣,對比實際工況,可知倣真實驗結果正確可靠。該簡化模型及分析方法可以用作驗證和模擬實驗,來指導產品設計,優化爐膛結構。
근거모형전조로로당조건결구화실제측시수거,채용ANSYS유한원분석연건건립일충로당간화이유모형。병대실측로당내온도수거분석계산,유차획득로당내벽종합환열계수,장기작위변계조건시가재모형중,진행은정태분석。통과분석방진실험획득적로당조건절면온도제도분포,온도분포곡선화망격절점온도구진,대비실제공황,가지방진실험결과정학가고。해간화모형급분석방법가이용작험증화모의실험,래지도산품설계,우화로당결구。
According to a certain type of furnace hearth structure and real data of test,using ANSYS analysis software to establish a simplified two-dimensional model of hearth.And the hearth temperature and the measured data analysis,thus obtained the inner wall of the furnace chamber integrated heat transfer coefficient,then the coefficient is used as the boundary conditions,is applied in the model for stability analysis.By using analysis of simulation experiments,the section temperature gradient distribution,temperature distribution curve and the grid node temperature matrix can be obtained in quickly.Showed that the experimental results are consistent with the actual usage of the furnace,therefore the simplified model and the analysis method can be used as the validation and simulation experiment,to guide the design and the optimization of furnace structure.