机械制造文摘-焊接分册
機械製造文摘-銲接分冊
궤계제조문적-한접분책
JIXIE ZHIZAO WENZHAI-HANJIE FENCE
2013年
6期
22-25
,共4页
方乃文%储继君%吕晓春%陈默%杨子佳%齐万利%李苏珊
方迺文%儲繼君%呂曉春%陳默%楊子佳%齊萬利%李囌珊
방내문%저계군%려효춘%진묵%양자가%제만리%리소산
WELDOX900低合金高强钢%预热温度%焊接工艺评定
WELDOX900低閤金高彊鋼%預熱溫度%銲接工藝評定
WELDOX900저합금고강강%예열온도%한접공예평정
WELDOX900 low alloy high strength steel%preheating temperature%welding procedure qualification
针对15 mm厚WELDOX900低合金高强钢工程化应用特点,采用自行设计的T形斜Y坡口裂纹敏感性试验确定了焊接预热温度,并按照ISO标准对WELDOX900钢焊接接头进行了焊接工艺评定。试验结果表明,焊接预热50℃时,焊接接头射线探伤合格,焊接成形、接头组织及性能良好。
針對15 mm厚WELDOX900低閤金高彊鋼工程化應用特點,採用自行設計的T形斜Y坡口裂紋敏感性試驗確定瞭銲接預熱溫度,併按照ISO標準對WELDOX900鋼銲接接頭進行瞭銲接工藝評定。試驗結果錶明,銲接預熱50℃時,銲接接頭射線探傷閤格,銲接成形、接頭組織及性能良好。
침대15 mm후WELDOX900저합금고강강공정화응용특점,채용자행설계적T형사Y파구렬문민감성시험학정료한접예열온도,병안조ISO표준대WELDOX900강한접접두진행료한접공예평정。시험결과표명,한접예열50℃시,한접접두사선탐상합격,한접성형、접두조직급성능량호。
Considering applications of WELDOX900 (δ=15mm) low alloy high strength steel in engineering ,the preheating temperature was determined by welding crack sensitivity test with the oblique Y groove of T -joint.Welding procedure qualification of WELDOX900 steel welded joints was carried out by ISO standards .The results show that the good welding appearance , qualified welded joints for radiographic inspection ,excellent microstructure and properties are obtained at 50℃preheating temperatare .