哈尔滨轴承
哈爾濱軸承
합이빈축승
JOURNAL OF HARBIN BEARING
2014年
3期
38-39
,共2页
内沟磨床%砂轮轴%动压轴承%供油系统%温升
內溝磨床%砂輪軸%動壓軸承%供油繫統%溫升
내구마상%사륜축%동압축승%공유계통%온승
inner groove grinder%grinding wheel shaft%hydrodynamic journal bearing%oil supply system%temperature rise
3MZ1310A内沟磨床的砂轮轴采用动压轴承支承。由于该动压轴承油箱体积小,使工作时油温升高,粘度降低,油楔刚度发生变化,造成磨削精度不稳定甚至抱轴现象。针对以上问题,对供油系统进行了改造,加大了油箱体积,延长了润滑油流动路线,加快了润滑油的流动速度,使润滑油工作温度恢复正常,解决了存在的问题,经改造后加工出的产品尺寸精度稳定在0.003mm以内。
3MZ1310A內溝磨床的砂輪軸採用動壓軸承支承。由于該動壓軸承油箱體積小,使工作時油溫升高,粘度降低,油楔剛度髮生變化,造成磨削精度不穩定甚至抱軸現象。針對以上問題,對供油繫統進行瞭改造,加大瞭油箱體積,延長瞭潤滑油流動路線,加快瞭潤滑油的流動速度,使潤滑油工作溫度恢複正常,解決瞭存在的問題,經改造後加工齣的產品呎吋精度穩定在0.003mm以內。
3MZ1310A내구마상적사륜축채용동압축승지승。유우해동압축승유상체적소,사공작시유온승고,점도강저,유설강도발생변화,조성마삭정도불은정심지포축현상。침대이상문제,대공유계통진행료개조,가대료유상체적,연장료윤활유류동로선,가쾌료윤활유적류동속도,사윤활유공작온도회복정상,해결료존재적문제,경개조후가공출적산품척촌정도은정재0.003mm이내。
3MZ1310A inner groove grinder grinding wheel shaft is supported by dynamic pressure bearing whose oil tank volume is small. The increased oil temperature and decreased oil viscosity during working result in the change of oil wedge rigidity, unstability of grinding precision and even the shaft not rotation. Aiming at the above problem, the oil supply system is developed by increasing the volume of oil tank, prolonging running line of lubricant , accelerating the running speed of lubricant, and lowing the oil temperature to normal level. The existing problem is resolved. The product dimensions are stabled within 0.003mm after the modiifcation.