CAJ | 학술논문

利用 Moldflow 分析软件，采用数值模拟试验方法，将正交试验和回归设计相结合，研究了熔体温度和保压压力对塑件翘曲量的影响规律，建立了信噪比回归方程。结果表明，在试验温度范围内，熔体温度越高，保压压力越大，信噪比越大，则塑件翘曲量越小。塑件成型工艺参数最终确定为：模具温度60℃、保压时间10 s、熔体温度240℃、保压压力115 MPa 及注射时间0.4 s。
이용 Moldflow 분석연건，채용수치모의시험방법，장정교시험화회귀설계상결합，연구료용체온도화보압압력대소건교곡량적영향규률，건립료신조비회귀방정。결과표명，재시험온도범위내，용체온도월고，보압압력월대，신조비월대，칙소건교곡량월소。소건성형공예삼수최종학정위：모구온도60℃、보압시간10 s、용체온도240℃、보압압력115 MPa 급주사시간0.4 s。
The influence rule of melt temperature and packing pressure on warpage were researched by software Mold-flow,through using the orthogonal regressive principle and combining orthogonal experiment with regression design,the re-gression equation of the S/N was established.The results showed that the warpage decreased with the rise of the melt tem-perature and packing pressure within the range of simulation experiment.At last,the optimum process parameters of injec-tion are that the mold temperature was 60 ℃,packing time was 10 s,melt temperature was 240 ℃,packing pressure was 1 1 5 MPa and injection time was 0.4 s.