水利与建筑工程学报
水利與建築工程學報
수리여건축공정학보
TECHNIQUE OF SEEPAGE CONTROL
2014年
3期
194-198
,共5页
水电站%调压井%露天上室式
水電站%調壓井%露天上室式
수전참%조압정%로천상실식
hydropower station%surge shaft%open-air upper-chamber type
对于中低水头长距离引水隧洞的电站,当调压井附近没有可利用的地质探洞、交通洞等加以改造作为调压井的上室时,采用洞室型式上室工程量大,不宜选用常规上室为洞室式的调压井。在上室达不到成洞条件,调压井处地形平缓,地质较好时,可采用露天上室式调压井。因露天上室式调压井具有限制水位继续上升,弃水储存功能,运行水锤压力小,运行安全,施工安全、滑模施工方便的优点,是调压井优先选用的型式。通过简单圆筒式、阻抗孔式、露天上室式三种型式的调压井比选,结果表明:在调压井高度较小,工程量较少,投资量较少,选用露天上室式更合理。
對于中低水頭長距離引水隧洞的電站,噹調壓井附近沒有可利用的地質探洞、交通洞等加以改造作為調壓井的上室時,採用洞室型式上室工程量大,不宜選用常規上室為洞室式的調壓井。在上室達不到成洞條件,調壓井處地形平緩,地質較好時,可採用露天上室式調壓井。因露天上室式調壓井具有限製水位繼續上升,棄水儲存功能,運行水錘壓力小,運行安全,施工安全、滑模施工方便的優點,是調壓井優先選用的型式。通過簡單圓筒式、阻抗孔式、露天上室式三種型式的調壓井比選,結果錶明:在調壓井高度較小,工程量較少,投資量較少,選用露天上室式更閤理。
대우중저수두장거리인수수동적전참,당조압정부근몰유가이용적지질탐동、교통동등가이개조작위조압정적상실시,채용동실형식상실공정량대,불의선용상규상실위동실식적조압정。재상실체불도성동조건,조압정처지형평완,지질교호시,가채용로천상실식조압정。인로천상실식조압정구유한제수위계속상승,기수저존공능,운행수추압력소,운행안전,시공안전、활모시공방편적우점,시조압정우선선용적형식。통과간단원통식、조항공식、로천상실식삼충형식적조압정비선,결과표명:재조압정고도교소,공정량교소,투자량교소,선용로천상실식경합리。
For the power station with medium-low water head and long-distance diversion tunnel ,and when there are no available geologic exploration tunnel and transport hole to be reformed near the surge shaft ,the engineering quantity is large when using cavern-typed upper-chamber for the surge shaft ,so it is not suitable to use the conventional upper-chamber as the cavern-typed surge shaft .When the upper-chamber could not reach the hole condition ,and the surge shaft is located in the conditions of gentle topogrophy and good geology ,the open-air upper-chamber-typed surge shaft could be used .The open-air upper-chamber-typed surge shaft has such advantages as limiting water level rise ,storing waste water .Also ,it needs small water hammer pressure to operate safely and it could be constructed safely .Furthermore it is suitable for slip-form construction .Therefor it is a prior-selecting type of the surge shaft .Through the comparison and selection for three types of the surge-shaft such as the simple cylindrical type ,impeded-hole type and open-air upper-chamber type ,it is shown that the open-air upper-chamber-typed surge shaft is more rational because of its smaller height ,less engineering quantity and less investment expenses .