CAJ | 학술논문

本文分析了能满足规程技术条件的控制衡器须具备的相应要求；指出模拟载荷试验不能完全替代物料试验的原因在于皮带效应，研制出能消除皮带张力变化干扰影响的新型皮带秤及皮带效应与散状物料相仿的新型模拟载荷装置，是拓展模拟载荷试验应用场合的两条出路。本文还阐述了计量器具检定周期不应“一刀切”的观点，并提出了以皮带秤使用中模拟栽荷试验的重复性和不确定度结果来合理拟定使用中检验间隔和检定周期的建议。
본문분석료능만족규정기술조건적공제형기수구비적상응요구；지출모의재하시험불능완전체대물료시험적원인재우피대효응，연제출능소제피대장력변화간우영향적신형피대칭급피대효응여산상물료상방적신형모의재하장치，시탁전모의재하시험응용장합적량조출로。본문환천술료계량기구검정주기불응“일도절”적관점，병제출료이피대칭사용중모의재하시험적중복성화불학정도결과래합리의정사용중검험간격화검정주기적건의。
This article analyzes the corresponding requirements of the controlling weighing instrument which can satisfy standard rule technical conditions, points out the simulated load test can＇t completely replace the material test because of belt effect, so de~elopirtg a new heir scale which can eliminate the interference effects of the changes in belt tension, and a new analog load device which can be similar to belt effect and bulk materials. This article also elaborates point of view of measuring instruments cycle should not be a ＂one-size-fits-all＂ , and proposes some suggestions about using repeatability and uncertainty results of simulate load test for a reasonable formulation of inspection intervals and test cycle to the belt scale.