牙体牙髓牙周病学杂志
牙體牙髓牙週病學雜誌
아체아수아주병학잡지
CHINESE JOURNAL OF CONSERVATIVE DENTISTRY
2014年
5期
294-296,308
,共4页
陈怀丽%赵静%何琴%王文梅%朱雅男
陳懷麗%趙靜%何琴%王文梅%硃雅男
진부려%조정%하금%왕문매%주아남
全酸蚀粘结剂%自酸蚀粘结剂%微拉伸粘结强度%湿粘结
全痠蝕粘結劑%自痠蝕粘結劑%微拉伸粘結彊度%濕粘結
전산식점결제%자산식점결제%미랍신점결강도%습점결
total etching%self-etching adhesive%microtensile bond strength%moist bonding
目的:通过微拉伸粘结强度检测法,比较3种不同的牙本质粘结剂 Single Bond 2、SE Bond和Easy One 的粘结强度,为临床应用提供参考。方法:选用30个新鲜拔除的人磨牙,磨除牙合面釉质暴露牙本质,随机分为3组,每组10个牙,分别使用Single Bond 2、SE Bond、Easy One 粘结剂,再用蓝色复合树脂充填5 mm 高度。在流水下,用慢速锯垂直于粘结面制备成1.0 mm ×1.0 mm横截面积的柱状试件,用微拉伸测试仪测试其微拉伸强度,用体视显微镜观察样本断裂类型,对微拉伸强度测试值和断裂类型进行统计学分析。结果:Single Bond 2组的微拉伸强度为(23.40±6.20)MPa,Easy One 组为(16.25±4.42)MPa,SE Bond 组(16.17±4.78)MPa。经方差分析,Single Bond 2组与另两组粘结剂微拉伸强度均有显著性差异(P<0.05),而SE Bond组和Easy One组无显著性差异(P>0.05)。结论:Single Bond 2粘结强度优于Easy One、SE Bond,3种粘结剂的粘结强度均可满足临床应用要求。
目的:通過微拉伸粘結彊度檢測法,比較3種不同的牙本質粘結劑 Single Bond 2、SE Bond和Easy One 的粘結彊度,為臨床應用提供參攷。方法:選用30箇新鮮拔除的人磨牙,磨除牙閤麵釉質暴露牙本質,隨機分為3組,每組10箇牙,分彆使用Single Bond 2、SE Bond、Easy One 粘結劑,再用藍色複閤樹脂充填5 mm 高度。在流水下,用慢速鋸垂直于粘結麵製備成1.0 mm ×1.0 mm橫截麵積的柱狀試件,用微拉伸測試儀測試其微拉伸彊度,用體視顯微鏡觀察樣本斷裂類型,對微拉伸彊度測試值和斷裂類型進行統計學分析。結果:Single Bond 2組的微拉伸彊度為(23.40±6.20)MPa,Easy One 組為(16.25±4.42)MPa,SE Bond 組(16.17±4.78)MPa。經方差分析,Single Bond 2組與另兩組粘結劑微拉伸彊度均有顯著性差異(P<0.05),而SE Bond組和Easy One組無顯著性差異(P>0.05)。結論:Single Bond 2粘結彊度優于Easy One、SE Bond,3種粘結劑的粘結彊度均可滿足臨床應用要求。
목적:통과미랍신점결강도검측법,비교3충불동적아본질점결제 Single Bond 2、SE Bond화Easy One 적점결강도,위림상응용제공삼고。방법:선용30개신선발제적인마아,마제아합면유질폭로아본질,수궤분위3조,매조10개아,분별사용Single Bond 2、SE Bond、Easy One 점결제,재용람색복합수지충전5 mm 고도。재류수하,용만속거수직우점결면제비성1.0 mm ×1.0 mm횡절면적적주상시건,용미랍신측시의측시기미랍신강도,용체시현미경관찰양본단렬류형,대미랍신강도측시치화단렬류형진행통계학분석。결과:Single Bond 2조적미랍신강도위(23.40±6.20)MPa,Easy One 조위(16.25±4.42)MPa,SE Bond 조(16.17±4.78)MPa。경방차분석,Single Bond 2조여령량조점결제미랍신강도균유현저성차이(P<0.05),이SE Bond조화Easy One조무현저성차이(P>0.05)。결론:Single Bond 2점결강도우우Easy One、SE Bond,3충점결제적점결강도균가만족림상응용요구。
AIM:To evaluate the dentin adhesive bond strength of 3 bonding systems.METHODS:Den-tin of 30 extracted human molars was exposed by removal of the occlusal enamel.The teeth were then randomly divided into 3 groups(n=10).A block of composite resin was bonded to dentin of th teeth respectively with Single Bond 2, Easy One and SE Bond according to manufactures’instructions.The teeth were cut vertically to their bonded surfaces and sectioned to obtain slice-shaped specimens with a slow-speed saw.Then the specimens were trimmed into col-umns with the bonded surface area of 1 .0 mm2 .The bonding strength of the specimens was measured by a Microtensile Tester.A microscope was used to observe the fracture modes.Data were statistically analyzed.RESULTS:The mean bond strength(MPa)of Single Bond 2,Easy One and SE Bond was 23.40 ±6.20,16.25 ±4.42;and 16.17 ±4.78 respectively.Single Bond 2 vs Easy One or SE Bond,P<0.05;Easy One vs SE Bond,P>0.05.CONCLUSION:Single Bond 2 can prodce stronger bonding strength to dentin than SE Bond and EASY OEN.