机床与液压
機床與液壓
궤상여액압
MACHINE TOOL & HYDRAULICS
2013年
22期
103-105
,共3页
丁时锋%李清香%王力群%韩泽东%黄强
丁時鋒%李清香%王力群%韓澤東%黃彊
정시봉%리청향%왕력군%한택동%황강
开槽机%膨胀管%气控系统%X-D图%FluidSIM-P
開槽機%膨脹管%氣控繫統%X-D圖%FluidSIM-P
개조궤%팽창관%기공계통%X-D도%FluidSIM-P
Grooving machine%Expansion pipe%Pneumatic system%X-D diagram%FluidSIM-P
基于膨胀管开槽机的工作要求，对其气控系统进行了程序分析及校正，运用X-D图法设计了气控系统的标准程序，给出了各气缸动作主控信号排除障碍后的执行信号表达式，完成了基于FluidSIM-P软件的膨胀管开槽机气控系统回路设计及模拟仿真。该气控系统在实际运行中取得了良好效果。
基于膨脹管開槽機的工作要求，對其氣控繫統進行瞭程序分析及校正，運用X-D圖法設計瞭氣控繫統的標準程序，給齣瞭各氣缸動作主控信號排除障礙後的執行信號錶達式，完成瞭基于FluidSIM-P軟件的膨脹管開槽機氣控繫統迴路設計及模擬倣真。該氣控繫統在實際運行中取得瞭良好效果。
기우팽창관개조궤적공작요구，대기기공계통진행료정서분석급교정，운용X-D도법설계료기공계통적표준정서，급출료각기항동작주공신호배제장애후적집행신호표체식，완성료기우FluidSIM-P연건적팽창관개조궤기공계통회로설계급모의방진。해기공계통재실제운행중취득료량호효과。
The program about the pneumatic control system of expansion pipe grooving machine was analyzed and corrected based on its working requirements. The standard procedure of pneumatic control system was designed by using X-D diagram,the signal ex-pressions of the cylinder main control signal after removing obstacles were implemented. The pneumatic circuit of the expansion pipe grooving machine was designed and the simulation was completed based on FluidSIM-P software. The actual operation of the pneumatic control system achieved good results.
