计算机工程与应用
計算機工程與應用
계산궤공정여응용
COMPUTER ENGINEERING AND APPLICATIONS
2013年
17期
199-203
,共5页
PERCLOS%眼睛睁开程度%疲劳判定
PERCLOS%眼睛睜開程度%疲勞判定
PERCLOS%안정정개정도%피로판정
PERCLOS%eyes open degree%determining fatigue
在用机器视觉系统监测驾驶员的眼睛疲劳状态时,由于图像采集与图像处理消耗一定的时间,降低了系统的采样率,正常情况下,眼睛的眨动过程非常短暂,过低的采样率会漏掉眼睛某些关键状态的信息。因此直接对视频进行研究并提出用描述统计方法确定眼睛的最大睁开值,进而应用PERCLOS方法进行疲劳判定。对视频序列图像进行抽样,研究不同采样时间间隔对PERCLOS值的影响。通过六名测试者的数据表明:当PERCLOS值在15%附近时疲劳现象明显,随疲劳程度加深PERCLOS值升高,通过对视频序列图像抽样调整采样时间间隔,发现采样间隔在40 ms到120 ms之间时, PERCLOS值比较稳定,最大的相对误差为20.17%,采样间隔时间大于120 ms时PERCLOS值的波动幅度较大,最大相对误差达到54.07%,会影响疲劳判定结果。
在用機器視覺繫統鑑測駕駛員的眼睛疲勞狀態時,由于圖像採集與圖像處理消耗一定的時間,降低瞭繫統的採樣率,正常情況下,眼睛的眨動過程非常短暫,過低的採樣率會漏掉眼睛某些關鍵狀態的信息。因此直接對視頻進行研究併提齣用描述統計方法確定眼睛的最大睜開值,進而應用PERCLOS方法進行疲勞判定。對視頻序列圖像進行抽樣,研究不同採樣時間間隔對PERCLOS值的影響。通過六名測試者的數據錶明:噹PERCLOS值在15%附近時疲勞現象明顯,隨疲勞程度加深PERCLOS值升高,通過對視頻序列圖像抽樣調整採樣時間間隔,髮現採樣間隔在40 ms到120 ms之間時, PERCLOS值比較穩定,最大的相對誤差為20.17%,採樣間隔時間大于120 ms時PERCLOS值的波動幅度較大,最大相對誤差達到54.07%,會影響疲勞判定結果。
재용궤기시각계통감측가사원적안정피로상태시,유우도상채집여도상처리소모일정적시간,강저료계통적채양솔,정상정황하,안정적잡동과정비상단잠,과저적채양솔회루도안정모사관건상태적신식。인차직접대시빈진행연구병제출용묘술통계방법학정안정적최대정개치,진이응용PERCLOS방법진행피로판정。대시빈서렬도상진행추양,연구불동채양시간간격대PERCLOS치적영향。통과륙명측시자적수거표명:당PERCLOS치재15%부근시피로현상명현,수피로정도가심PERCLOS치승고,통과대시빈서렬도상추양조정채양시간간격,발현채양간격재40 ms도120 ms지간시, PERCLOS치비교은정,최대적상대오차위20.17%,채양간격시간대우120 ms시PERCLOS치적파동폭도교대,최대상대오차체도54.07%,회영향피로판정결과。
when employing the machine vision system for monitoring the driver’s eyes fatigue state, due to image acquisition and image processing takes some time, reducing the system’s sampling rate, and the blink process is very short under normal circumstances, low sampling rate will loss the eyes of some key state information. This article directly studies the video image sequences, and uses the statistical methods to determine the maximum of open eye, then applies the PERCLOS method to determine the extent of eye fatigue. Study the varied sample intervals to impact on the PERCLOS value by sampling the video image sequences. Through six testers’data show that, when the PERCLOS value reaches 15%, the sign of fatigue is obvious, with the deepening of fatigue, the PERCLOS value increases, adjusting the sample interval, it is found that when sample interval between the 40~120 ms, the PERCLOS value is relatively stable, the maximum relative error is 20.17%, but when the sample interval is greater than 120 ms, the PERCLOS fluctuation is high, the maximum relative error is 54.07%, which will affect the fatigue judgement.