焊管
銲管
한관
WELDED PIPE AND TUBE
2013年
10期
64-67
,共4页
魏伟荣%杨专钊%刘元永%王高峰
魏偉榮%楊專釗%劉元永%王高峰
위위영%양전쇠%류원영%왕고봉
焊管%高钢级厚壁海管%拉伸性能%抗拉强度%屈服强度%屈强比%延伸率
銲管%高鋼級厚壁海管%拉伸性能%抗拉彊度%屈服彊度%屈彊比%延伸率
한관%고강급후벽해관%랍신성능%항랍강도%굴복강도%굴강비%연신솔
welded pipe%high grade submarine pipeline with heavy wall thickness%tensile property%tensile strength%yield strength%yield ratio%elongation ratio
结合中海油南海荔湾3-1海底输气管道项目,通过试验对高钢级厚壁海管的抗拉强度、屈服强度、屈强比以及延伸率等进行了研究分析。结果表明,无论是纵向还是横向,板状试样的抗拉强度和断后伸长率平均值均高于圆棒试样;而横向板状试样宽度的变化对其抗拉强度的影响很小;上、下表面抗拉强度平均值高于壁厚中心平均值;不同宽度的板状试样,宽度越大,断后伸长率越大;不同壁厚位置的小尺寸棒状试样的断后伸长率变化不大。纵向板状试样的屈服强度、屈强比基本高于圆棒试样;横向板状试样屈服强度、屈强比基本低于圆棒试样,壁厚上、下表面屈服强度、屈强比高于壁厚中心平均值。
結閤中海油南海荔灣3-1海底輸氣管道項目,通過試驗對高鋼級厚壁海管的抗拉彊度、屈服彊度、屈彊比以及延伸率等進行瞭研究分析。結果錶明,無論是縱嚮還是橫嚮,闆狀試樣的抗拉彊度和斷後伸長率平均值均高于圓棒試樣;而橫嚮闆狀試樣寬度的變化對其抗拉彊度的影響很小;上、下錶麵抗拉彊度平均值高于壁厚中心平均值;不同寬度的闆狀試樣,寬度越大,斷後伸長率越大;不同壁厚位置的小呎吋棒狀試樣的斷後伸長率變化不大。縱嚮闆狀試樣的屈服彊度、屈彊比基本高于圓棒試樣;橫嚮闆狀試樣屈服彊度、屈彊比基本低于圓棒試樣,壁厚上、下錶麵屈服彊度、屈彊比高于壁厚中心平均值。
결합중해유남해려만3-1해저수기관도항목,통과시험대고강급후벽해관적항랍강도、굴복강도、굴강비이급연신솔등진행료연구분석。결과표명,무론시종향환시횡향,판상시양적항랍강도화단후신장솔평균치균고우원봉시양;이횡향판상시양관도적변화대기항랍강도적영향흔소;상、하표면항랍강도평균치고우벽후중심평균치;불동관도적판상시양,관도월대,단후신장솔월대;불동벽후위치적소척촌봉상시양적단후신장솔변화불대。종향판상시양적굴복강도、굴강비기본고우원봉시양;횡향판상시양굴복강도、굴강비기본저우원봉시양,벽후상、하표면굴복강도、굴강비고우벽후중심평균치。
In this article,combined with CNOOC Nanhai Liwan 3-1 submarine gas pipeline project,it studied and analyzed tensile strength,yield strength,yield ratio and elongation of high grade submarine pipe with heavy wall thickness through tests. The results showed that both longitudinal and transverse,the tensile strength and the average value of elongation of plate specimen both are higher than those of round bar specimen,while the width variation of the transverse plate specimen slightly affects its tensile strength,the average value of the upper and lower surface tensile strength both are higher than those of the wall thickness center,for different width plate specimen,the bigger the width is,the greater elongation ratio after fracture is, and little variation of percentage elongation after fracture of small size round bar specimen for different wall thickness location. The yield strength and yield ratio of longitudinal plate specimen are higher than those of round bar specimen,the yield strength and yield ratio of transverse plate specimen are lower than those of round bar specimen,and the yield strength and yield ratio of the wall thickness upper and lower surface are higher than those of the average value of wall thickness center.