价值工程
價值工程
개치공정
VALUE ENGINEERING
2013年
22期
38-39,40
,共3页
裂纹%未熔合%未焊透%射线检测%超声波检测
裂紋%未鎔閤%未銲透%射線檢測%超聲波檢測
렬문%미용합%미한투%사선검측%초성파검측
crack%incomplete fusion%incomplete penetration%ray testing%ultrasonic testing
分析特种设备制造行业无损检测现状,存在的问题;制作典型人工焊接缺陷,包括裂纹、未熔合、未焊透及条状夹渣等缺陷。对试件进行100%射线检测,确定缺陷性质、大小和位置;用K2.0超声波探头在筒体侧进行检测;用不同K值的探头(K1.5、K2.0和K2.5)在封头侧分别进行检测。对两种缺陷评定方式的结果进行对比分析,确定超声波探伤应采取的方案。
分析特種設備製造行業無損檢測現狀,存在的問題;製作典型人工銲接缺陷,包括裂紋、未鎔閤、未銲透及條狀夾渣等缺陷。對試件進行100%射線檢測,確定缺陷性質、大小和位置;用K2.0超聲波探頭在筒體側進行檢測;用不同K值的探頭(K1.5、K2.0和K2.5)在封頭側分彆進行檢測。對兩種缺陷評定方式的結果進行對比分析,確定超聲波探傷應採取的方案。
분석특충설비제조행업무손검측현상,존재적문제;제작전형인공한접결함,포괄렬문、미용합、미한투급조상협사등결함。대시건진행100%사선검측,학정결함성질、대소화위치;용K2.0초성파탐두재통체측진행검측;용불동K치적탐두(K1.5、K2.0화K2.5)재봉두측분별진행검측。대량충결함평정방식적결과진행대비분석,학정초성파탐상응채취적방안。
The status and problems of nondestructive testing of special equipment manufacturing industry are analyzed in this paper. Typical artificial welding defects including cracks, incomplete fusion, incomplete penetration and stripe slag inclusion are made. 100%radiographic testing is done to the specimen to determine the nature, size and position of the defect. The K2.0 ultrasonic probe is used to test the cylinder side;different K value probes(K1.5、K2.0 and K2.5)are used to test the head side respectively. The results of two kinds of defect assessment methods are analyzed to determine the solution that should be taken in ultrasonic flaw detection.