辽宁科技学院学报
遼寧科技學院學報
료녕과기학원학보
JOURNAL OF LIAONING INSTITUTE OF SCIENCE AND TECHNOLOGY
2014年
3期
18-19
,共2页
处理方法%分析仪器%二次污染
處理方法%分析儀器%二次汙染
처리방법%분석의기%이차오염
Treatment method%Analyzer%Secondary pollution
文章采用TC-436氮氧仪对分别使用碳化硅锯片打磨、砂轮打磨和板挫打磨后的氧试样在各种实验条件下进行分析,把分析数据归类比较,得出用板挫、酸处理后的试样表面光洁度最好,二次污染物去除的最干净,可以保证分析结果的精确度和准确度。
文章採用TC-436氮氧儀對分彆使用碳化硅鋸片打磨、砂輪打磨和闆挫打磨後的氧試樣在各種實驗條件下進行分析,把分析數據歸類比較,得齣用闆挫、痠處理後的試樣錶麵光潔度最好,二次汙染物去除的最榦淨,可以保證分析結果的精確度和準確度。
문장채용TC-436담양의대분별사용탄화규거편타마、사륜타마화판좌타마후적양시양재각충실험조건하진행분석,파분석수거귀류비교,득출용판좌、산처리후적시양표면광길도최호,이차오염물거제적최간정,가이보증분석결과적정학도화준학도。
In this paper , the TC-436 nitrogen-oxygen analyzer is used to analyze steel samples , which polished with carborundum saw, grinding wheel and file respectively .By comparing and classifying analyzed data under different test condition , it can be seen that the surface of sample after treatment with file and acid is smoothest and is cleanest from cleaning secondary pollution , and high preci-sion and accuracy of analyzed results are obtained .