武钢技术
武鋼技術
무강기술
WUHAN IRON AND STEEL CORPORATION TECHNOLOGY
2014年
4期
16-18
,共3页
何金平%钱龙%王春锋%刘先同%叶飞
何金平%錢龍%王春鋒%劉先同%葉飛
하금평%전룡%왕춘봉%류선동%협비
中间包涂料%基质组成%氧化硅微粉%氧化铝微粉
中間包塗料%基質組成%氧化硅微粉%氧化鋁微粉
중간포도료%기질조성%양화규미분%양화려미분
tundish coating%matrix composition%microsilica%alumina powder
通过调整镁质中间包涂料的基质配比,以期提高中间包涂料的中温强度。结果表明:随着 SiO2微粉加入量的增多,涂料经中温处理后,抗折强度逐渐提高;当 SiO2微粉加入量在4%~8%时,常温抗折强度、常温耐压强度、线变化率、抗渣等性能变化不大;调整 Al2 O3微粉加入量,抗渣性能有所降低;随着 Al2 O3微粉加入量的增加,试样的高温抗折强度有明显提高。
通過調整鎂質中間包塗料的基質配比,以期提高中間包塗料的中溫彊度。結果錶明:隨著 SiO2微粉加入量的增多,塗料經中溫處理後,抗摺彊度逐漸提高;噹 SiO2微粉加入量在4%~8%時,常溫抗摺彊度、常溫耐壓彊度、線變化率、抗渣等性能變化不大;調整 Al2 O3微粉加入量,抗渣性能有所降低;隨著 Al2 O3微粉加入量的增加,試樣的高溫抗摺彊度有明顯提高。
통과조정미질중간포도료적기질배비,이기제고중간포도료적중온강도。결과표명:수착 SiO2미분가입량적증다,도료경중온처리후,항절강도축점제고;당 SiO2미분가입량재4%~8%시,상온항절강도、상온내압강도、선변화솔、항사등성능변화불대;조정 Al2 O3미분가입량,항사성능유소강저;수착 Al2 O3미분가입량적증가,시양적고온항절강도유명현제고。
The intermediate temperature strength of tundish coating was improved by ad-j usting the composition of matrix.The results showed that:bending strength of sam-ples was gradually improved after the intermediate temperature treatment;flexural strength has no obvious change after the high temperature treatment.When the amount of microsilica was 4 %-8 %,flexural strength,compressive strength,linear change rate and slag resistance tended to be stable;room temperature flexural compressive strength were not significantly improved and slag resistance was decreased by the use of alumina powder.When adding an excessive amount of alumina powder in the matrix,high tem-perature flexural strength of sample was improved significantly.