工业水处理
工業水處理
공업수처리
INDUSTRIAL WATER TREATMENT
2014年
8期
82-83,84
,共3页
含氟废水%混凝沉淀%吸附
含氟廢水%混凝沉澱%吸附
함불폐수%혼응침정%흡부
fluoride-containing wastewater%coagulation precipitation%adsorption
针对某石英制品企业排放的高浓度含氟废水,采用初沉-混凝沉淀-吸附组合工艺进行处理。工程实践结果表明:在加药量维持相对稳定的情况下,出水氟化物质量浓度可稳定控制在5 mg/L以下,达到了当地环境保护局要求的控制标准。
針對某石英製品企業排放的高濃度含氟廢水,採用初沉-混凝沉澱-吸附組閤工藝進行處理。工程實踐結果錶明:在加藥量維持相對穩定的情況下,齣水氟化物質量濃度可穩定控製在5 mg/L以下,達到瞭噹地環境保護跼要求的控製標準。
침대모석영제품기업배방적고농도함불폐수,채용초침-혼응침정-흡부조합공예진행처리。공정실천결과표명:재가약량유지상대은정적정황하,출수불화물질량농도가은정공제재5 mg/L이하,체도료당지배경보호국요구적공제표준。
The highly concentrated fluoride-containing wastewater discharged from a quartz-producing enterprise has been treated by preliminary sedimentation-coagulation precipitatiobn-adsorption process. The results of engineering practice show that when the dosing amount keeps stable ,the mass concentration of effluent fluoride can be controlled steadily under 5 mg/L,reaching the discharge standards required by the local Environmental Protection Agency.