岩土力学
巖土力學
암토역학
ROCK AND SOIL MECHANICS
2014年
8期
2184-2190
,共7页
输电线路%开挖类基础%作用组合%极限状态%承载特性
輸電線路%開挖類基礎%作用組閤%極限狀態%承載特性
수전선로%개알류기출%작용조합%겁한상태%승재특성
transmission line%excavated foundations%action combination%limit state%bearing characteristic
合理选用由杆塔结构传递而来的作用效应是地基基础设计的重要前提,为了确定输电杆塔开挖类基础基于极限状态设计的作用组合值,分析了输电杆塔对基础的作用特点,并针对上部杆塔对基础作用的3种主要工况,利用静载荷试验结果研究了开挖类基础与地基结构体系的承载特性、破坏特征及其易超越的主要极限状态,并给出了地基基础体系设计时所采用的作用组合,研究表明,上拔和倾覆工况下常规条件开挖类基础承载过大时表现为脆性破坏,按承载能力极限状态设计,采用由可变荷载控制的基本组合;下压工况下开挖类基础的荷载与位移关系曲线一般为非陡降型,按正常使用极限状态设计,主要采用标准组合和准永久组合。
閤理選用由桿塔結構傳遞而來的作用效應是地基基礎設計的重要前提,為瞭確定輸電桿塔開挖類基礎基于極限狀態設計的作用組閤值,分析瞭輸電桿塔對基礎的作用特點,併針對上部桿塔對基礎作用的3種主要工況,利用靜載荷試驗結果研究瞭開挖類基礎與地基結構體繫的承載特性、破壞特徵及其易超越的主要極限狀態,併給齣瞭地基基礎體繫設計時所採用的作用組閤,研究錶明,上拔和傾覆工況下常規條件開挖類基礎承載過大時錶現為脆性破壞,按承載能力極限狀態設計,採用由可變荷載控製的基本組閤;下壓工況下開挖類基礎的荷載與位移關繫麯線一般為非陡降型,按正常使用極限狀態設計,主要採用標準組閤和準永久組閤。
합리선용유간탑결구전체이래적작용효응시지기기출설계적중요전제,위료학정수전간탑개알류기출기우겁한상태설계적작용조합치,분석료수전간탑대기출적작용특점,병침대상부간탑대기출작용적3충주요공황,이용정재하시험결과연구료개알류기출여지기결구체계적승재특성、파배특정급기역초월적주요겁한상태,병급출료지기기출체계설계시소채용적작용조합,연구표명,상발화경복공황하상규조건개알류기출승재과대시표현위취성파배,안승재능력겁한상태설계,채용유가변하재공제적기본조합;하압공황하개알류기출적하재여위이관계곡선일반위비두강형,안정상사용겁한상태설계,주요채용표준조합화준영구조합。
Reasonable selection of action combinations is an important prerequisite for ground and foundation design. To determine action combinations based on limited states design for excavated foundations of transmission pole and tower, force characteristic of foundations was analyzed. According to the main three action conditions on foundations of transmission pole and tower, bearing and failure characteristic and easier exceeding limited states of structural system including excavated foundation and ground were studied, and action design combinations of the ground-foundation system were provided. The failure characteristic of excavated foundations bearing too much load is brittle under uplifting or overturning conditions, and fundamental combination controlled by variable load are adopted as required by ultimate limit state design. The relationship curves between load and displacement of excavated foundations are non-steep-fall under downward force condition, based on serviceability limit state design, characteristic or quasi-permanent combinations should be mainly used.