CAJ | 학술논문

根据《火电厂大气污染物排放标准》（GB 13223-2011）的要求，2014-07，红河发电公司SO2的排放浓度将执行200 mg/m3的标准。而实际燃用的煤质条件与设计煤种之间的偏差较大，SO2的质量浓度远高于设计值，不能满足新的排放标准要求。采用石灰石-石膏湿法脱硫装置进行脱硫改造，此次改造按照 SO2排放的质量浓度小于200 mg/Nm3（标态，干基，体积分数为6%的氧）进行设计。
근거《화전엄대기오염물배방표준》（GB 13223-2011）적요구，2014-07，홍하발전공사SO2적배방농도장집행200 mg/m3적표준。이실제연용적매질조건여설계매충지간적편차교대，SO2적질량농도원고우설계치，불능만족신적배방표준요구。채용석회석-석고습법탈류장치진행탈류개조，차차개조안조 SO2배방적질량농도소우200 mg/Nm3（표태，간기，체적분수위6%적양）진행설계。
According to“Thermal Power Plant Air Pollutant Emission Standards”(GB 13223-2011)requirements, 2014-07, SO2 emission concentration Honghe Power Generation Company will perform 200 mg/m3 standards. The deviation of the actual conditions of coal burning coals and design between the larger mass concentrations of SO2 is much higher than the design value, can not meet the new emissions standards. Limestone-gypsum wet FGD desulphurization devices, in accordance with the transformation of the mass concentration of SO2 emissions of less than 200 mg/Nm3(standard state, dry basis, the volume fraction of 6%oxygen)design.