福建林业科技
福建林業科技
복건임업과기
JOURNAL OF FUJIAN FORESTRY SCIENCE AND TECHNOLOGY
2014年
3期
94-99
,共6页
邢珍珍%陈朱辉%岳贤田%曾韬
邢珍珍%陳硃輝%嶽賢田%曾韜
형진진%진주휘%악현전%증도
枫香树脂%丙烯酸酯%乳液聚合%压敏胶
楓香樹脂%丙烯痠酯%乳液聚閤%壓敏膠
풍향수지%병희산지%유액취합%압민효
Chinese Sweetgum Resin%acrylic ester%emulsion polymerization%PSA
以混合丙烯酸酯为共聚单体,枫香树脂为增粘剂,过硫酸铵( APS)为引发剂,十二烷基硫酸钠( SDS)、烷基酚聚氧乙烯醚( OP-10)为乳化剂,采用预乳化半连续乳液聚合法制备枫香树脂-丙烯酸酯复合乳液。研究枫香树脂用量对单体转化率、凝胶率、玻璃化转变温度、热稳定性以及压敏胶( PSA )粘接性能的影响。结果表明,在枫香树脂一定的质量分数范围内,随着枫香树脂用量的增加,分子量、凝胶率、热稳定性、玻璃化转变温度随之增加。枫香树脂的适宜用量为质量分数10.0%,此时压敏胶的初粘力为16#,180°剥离强度为10.12 N·25 mm-1。
以混閤丙烯痠酯為共聚單體,楓香樹脂為增粘劑,過硫痠銨( APS)為引髮劑,十二烷基硫痠鈉( SDS)、烷基酚聚氧乙烯醚( OP-10)為乳化劑,採用預乳化半連續乳液聚閤法製備楓香樹脂-丙烯痠酯複閤乳液。研究楓香樹脂用量對單體轉化率、凝膠率、玻璃化轉變溫度、熱穩定性以及壓敏膠( PSA )粘接性能的影響。結果錶明,在楓香樹脂一定的質量分數範圍內,隨著楓香樹脂用量的增加,分子量、凝膠率、熱穩定性、玻璃化轉變溫度隨之增加。楓香樹脂的適宜用量為質量分數10.0%,此時壓敏膠的初粘力為16#,180°剝離彊度為10.12 N·25 mm-1。
이혼합병희산지위공취단체,풍향수지위증점제,과류산안( APS)위인발제,십이완기류산납( SDS)、완기분취양을희미( OP-10)위유화제,채용예유화반련속유액취합법제비풍향수지-병희산지복합유액。연구풍향수지용량대단체전화솔、응효솔、파리화전변온도、열은정성이급압민효( PSA )점접성능적영향。결과표명,재풍향수지일정적질량분수범위내,수착풍향수지용량적증가,분자량、응효솔、열은정성、파리화전변온도수지증가。풍향수지적괄의용량위질량분수10.0%,차시압민효적초점력위16#,180°박리강도위10.12 N·25 mm-1。
Chinese Sweetgum Resin/acrylate composite emulsion was prepared by pre-emulsification semi-continual emulsion poly-merization with mixed acrylic ester as monomer ,Chinese Sweetgum Resin as tackifying resin ,ammonium persulfate ( APS) as initiator and sodium dodecyl sulfate(SDS),alkyl phenol polyoxyethylene ether (OP-10)as emulsifier.The effects of amount of Chinese Sweet-gum Resin on the conversion of monomer ,the gel rate,glass transition temperature,thermal stability and the bonding performance of PSA;The results showed that within the scope of the mass fraction of Chinese Sweetgum Resin ,with the increase of Chinese Sweet-gum Resincontent ,molecular weight and gel rate ,thermal stability ,glass transition temperature increased.And the pressure sensitive adhesive was obtained and its probe tack was 16#,peel strength was 10.12 N· 25 mm-1 ,when mass fraction of Chinese Sweetgum Resin was 10%wt.