湿法冶金
濕法冶金
습법야금
HYDROMETALLURGY OF CHINA
2014年
5期
361-364
,共4页
温葆林%谢添%梁勇%杨亮%刘玉城%郭斗斗%郭年祥
溫葆林%謝添%樑勇%楊亮%劉玉城%郭鬥鬥%郭年祥
온보림%사첨%량용%양량%류옥성%곽두두%곽년상
镀铜铁针%氨水%浸出%铜
鍍銅鐵針%氨水%浸齣%銅
도동철침%안수%침출%동
waste plated copper iron needles%ammonia%leaching%copper
研究了从电子工业中产生的镀铜铁针中回收铜。用氨水和硫酸铵混合溶液作浸出剂,控制反应时间为120 min、总氨浓度为4 mol/L、氨铵量比为1∶1、空气流量为1 L/min、液固体积质量比为5∶1、搅拌速度为400 r/min、温度为40℃,结果表明,铜浸出率达99%,且铁针未受损伤。
研究瞭從電子工業中產生的鍍銅鐵針中迴收銅。用氨水和硫痠銨混閤溶液作浸齣劑,控製反應時間為120 min、總氨濃度為4 mol/L、氨銨量比為1∶1、空氣流量為1 L/min、液固體積質量比為5∶1、攪拌速度為400 r/min、溫度為40℃,結果錶明,銅浸齣率達99%,且鐵針未受損傷。
연구료종전자공업중산생적도동철침중회수동。용안수화류산안혼합용액작침출제,공제반응시간위120 min、총안농도위4 mol/L、안안량비위1∶1、공기류량위1 L/min、액고체적질량비위5∶1、교반속도위400 r/min、온도위40℃,결과표명,동침출솔체99%,차철침미수손상。
Recovery of copper from copper-plated iron needle come from electronics industry was conducted .Using mixed solution of ammonia and ammonium sulphate with oxidation in air as leaching agent ,under the conditions of reaction time of 120 min ,total ammonia concentration of 4 mol/L , n(ammonia)/n(ammonium) of 1/1 ,air flow of 1 L/min ,the ratio between liquid volume and solid mass of 5∶1 ,stirring speed of 400 r/min ,temperature of 40 ℃ ,the leaching rate of copper can reach as high as 99% ,the iron needles is not damaged .