混凝土与水泥制品
混凝土與水泥製品
혼응토여수니제품
CHINA CONCRETE AND CEMENT PRODUCTS
2014年
9期
6-10
,共5页
王朝强%谭克锋%朱建舟%张韶华%丁文文
王朝彊%譚剋鋒%硃建舟%張韶華%丁文文
왕조강%담극봉%주건주%장소화%정문문
免压蒸%高强混凝土%抗冻融%抗硫酸盐
免壓蒸%高彊混凝土%抗凍融%抗硫痠鹽
면압증%고강혼응토%항동융%항류산염
Non-autoclaved%High-strength concrete%Freezing-thaw resistance%Sulfate resistance
为探索养护制度对采用水泥-硅灰-矿渣粉复合胶凝材料的C80桩用高强混凝土耐久性性能的影响规律,研究了不同养护条件下(蒸汽养护和标准养护)C80桩用高强混凝土抗冻融和抗硫酸盐性能,并分析了不同蒸汽养护恒温静停时间对复合胶凝材料水化程度的影响。试验结果表明,蒸汽养护能有效提高预应力离心桩用C80高强混凝土早期(28d)强度;标准养护下的预应力离心桩用C80高强混凝土抗冻融和抗硫酸盐性能要优于蒸汽养护,其中水泥用量为400kg/m3,矿粉与硅灰互掺近1:1时,抗冻等级可达F450,抗硫酸盐等级可达KS150以上;蒸汽养护最高恒温不超过80益对提高水泥基胶凝材料耐久性更加有利。
為探索養護製度對採用水泥-硅灰-礦渣粉複閤膠凝材料的C80樁用高彊混凝土耐久性性能的影響規律,研究瞭不同養護條件下(蒸汽養護和標準養護)C80樁用高彊混凝土抗凍融和抗硫痠鹽性能,併分析瞭不同蒸汽養護恆溫靜停時間對複閤膠凝材料水化程度的影響。試驗結果錶明,蒸汽養護能有效提高預應力離心樁用C80高彊混凝土早期(28d)彊度;標準養護下的預應力離心樁用C80高彊混凝土抗凍融和抗硫痠鹽性能要優于蒸汽養護,其中水泥用量為400kg/m3,礦粉與硅灰互摻近1:1時,抗凍等級可達F450,抗硫痠鹽等級可達KS150以上;蒸汽養護最高恆溫不超過80益對提高水泥基膠凝材料耐久性更加有利。
위탐색양호제도대채용수니-규회-광사분복합효응재료적C80장용고강혼응토내구성성능적영향규률,연구료불동양호조건하(증기양호화표준양호)C80장용고강혼응토항동융화항류산염성능,병분석료불동증기양호항온정정시간대복합효응재료수화정도적영향。시험결과표명,증기양호능유효제고예응력리심장용C80고강혼응토조기(28d)강도;표준양호하적예응력리심장용C80고강혼응토항동융화항류산염성능요우우증기양호,기중수니용량위400kg/m3,광분여규회호참근1:1시,항동등급가체F450,항류산염등급가체KS150이상;증기양호최고항온불초과80익대제고수니기효응재료내구성경가유리。
To explore the influence of curing system on the permeability of C80 high-strength concrete which based on cement- silica fume-slag compound cementitious materials, the durability of C80 high-strength concrete under differ-ent curing conditions (steam-curing and standard curing) are studied, and the effect of different steam-curing thermostatic rest period on the hydration degree of compound cementitious materials is also studied. The results show that steam-curing is propitious to increase the strength of concrete in early age (28d). The freezing-thaw resistance and sulfate resistance of concrete under the standard curing is superior to the steam-curing, and the cement content in 400kg/m3, mineral powder and silica fume mixed close to 1:1, under these conditions, the mechanical property and working performance of the non-autoclaved C80 concrete all meet the standard requirements, the frost resistance level can reach F450, anti-sulfate corro-sion performance level more than KS150. In addition, when the highest curing temperature is below 80℃, it is much better for the increase of impermeability of compound cementitious materials.