中国石油大学学报(自然科学版)
中國石油大學學報(自然科學版)
중국석유대학학보(자연과학판)
JOURNAL OF CHINA UNIVERSITY OF PETROLEUM(EDITION OF NATURAL SCIENCE)
2014年
5期
96-101
,共6页
王子振%王瑞和%单珣%臧艳彬%张锐%李明忠
王子振%王瑞和%單珣%臧豔彬%張銳%李明忠
왕자진%왕서화%단순%장염빈%장예%리명충
碳酸盐岩%孔隙结构%地层压力预测%纵波速度%压力偏差
碳痠鹽巖%孔隙結構%地層壓力預測%縱波速度%壓力偏差
탄산염암%공극결구%지층압력예측%종파속도%압력편차
carbonate rocks%pore structure%pore-pressure prediction%P-wave velocity%pressure deviation
碳酸盐岩异常地层压力成因不同于碎屑沉积岩的欠压实机制,其纵波速度-孔隙度关系分散,采用常规方法进行碳酸盐岩地层压力预测具有很大的不确定性。基于等效介质理论,计算不同孔隙结构碳酸盐岩的纵波速度,在此基础上,分析孔隙结构导致的常规地层压力预测方法的预测偏差。结果表明:在应力状态、矿物组成和孔隙度相同条件下,裂隙类孔隙使地层压力预测结果偏高,易造成井漏、储层污染等问题;溶孔类孔隙使地层压力预测结果偏低,易诱发溢流、井涌等复杂情况;当裂缝、溶孔共存时,地层压力预测偏差的正负不仅受裂隙与溶孔相对体积比的影响,也受其绝对体积含量的控制;对于复杂孔隙结构碳酸盐岩,油气钻井工程中采用常规的地层压力预测方法和井身结构设计系数存在较大的安全隐患。
碳痠鹽巖異常地層壓力成因不同于碎屑沉積巖的欠壓實機製,其縱波速度-孔隙度關繫分散,採用常規方法進行碳痠鹽巖地層壓力預測具有很大的不確定性。基于等效介質理論,計算不同孔隙結構碳痠鹽巖的縱波速度,在此基礎上,分析孔隙結構導緻的常規地層壓力預測方法的預測偏差。結果錶明:在應力狀態、礦物組成和孔隙度相同條件下,裂隙類孔隙使地層壓力預測結果偏高,易造成井漏、儲層汙染等問題;溶孔類孔隙使地層壓力預測結果偏低,易誘髮溢流、井湧等複雜情況;噹裂縫、溶孔共存時,地層壓力預測偏差的正負不僅受裂隙與溶孔相對體積比的影響,也受其絕對體積含量的控製;對于複雜孔隙結構碳痠鹽巖,油氣鑽井工程中採用常規的地層壓力預測方法和井身結構設計繫數存在較大的安全隱患。
탄산염암이상지층압력성인불동우쇄설침적암적흠압실궤제,기종파속도-공극도관계분산,채용상규방법진행탄산염암지층압력예측구유흔대적불학정성。기우등효개질이론,계산불동공극결구탄산염암적종파속도,재차기출상,분석공극결구도치적상규지층압력예측방법적예측편차。결과표명:재응력상태、광물조성화공극도상동조건하,렬극류공극사지층압력예측결과편고,역조성정루、저층오염등문제;용공류공극사지층압력예측결과편저,역유발일류、정용등복잡정황;당렬봉、용공공존시,지층압력예측편차적정부불부수렬극여용공상대체적비적영향,야수기절대체적함량적공제;대우복잡공극결구탄산염암,유기찬정공정중채용상규적지층압력예측방법화정신결구설계계수존재교대적안전은환。
The origin of abnormal pore pressure in carbonate rocks is different from that of clastic sedimentary rocks. P-wave velocity and porosity have poor correlation in carbonate rocks, which results in high uncertainty in pore-pressure prediction u-sing common methods. Based on the effective media theory, the P-wave velocity in carbonates with different types of pore structure was calculated, and then the deviation of pore-pressure predicted with conventional methods was analyzed. The re-sults show that under the same stress condition, mineral composition and porosity, the pore-pressure of carbonate formation with crack type porosity tends to be over-estimated, which can cause lost circulation and reservoir damage during drilling. On the other hand, the pore-pressure of carbonate formation with moldic or vug type porosity can be under-estimated, which may lead to well kick or even blowout. For carbonate formations with both crack and moldic types of porosity, whether the predic-ted pore pressure is under-or over-estimated depends not only on the relative volume fraction of cracks and vugs, but also on their absolute volumes. Therefore, there are safety concerns when conventional pore-pressure prediction method and casing program design method are used during drilling carbonates with complicated pore structure.