哈尔滨工程大学学报
哈爾濱工程大學學報
합이빈공정대학학보
JOURNAL OF HARBIN ENGINEERING UNIVERSITY
2014年
10期
1183-1188,1235
,共7页
杨娜娜%王伟%董一帆%姚熊亮
楊娜娜%王偉%董一帆%姚熊亮
양나나%왕위%동일범%요웅량
天线罩%复合材料%螺栓连接%渐近损伤分析%试验研究
天線罩%複閤材料%螺栓連接%漸近損傷分析%試驗研究
천선조%복합재료%라전련접%점근손상분석%시험연구
radome%steel-to-composite%joints%progressive damage analysis%experiments
针对复合材料天线罩螺栓连接结构的损伤失效问题,采用试验和渐近损伤分析方法对复合材料天线罩螺栓连接结构的损伤失效进行了研究,分析了螺栓连接结构在等效风载压力和拉力作用下的失效过程和失效强度,并对天线罩连接结构折角位置玻璃钢蒙皮的过渡方式对其力学性能的影响进行了分析。试验和数值研究结果表明,连接结构试件的初始破坏均表现为玻璃钢蒙皮与泡沫芯材间的层间开裂,初始开裂载荷为0.7倍左右的结构失效载荷,玻璃钢蒙皮采用隔层断开过渡的加工工艺可显著提高天线罩连接结构的强度,数值预测的结构失效强度与试验结果吻合较好。
針對複閤材料天線罩螺栓連接結構的損傷失效問題,採用試驗和漸近損傷分析方法對複閤材料天線罩螺栓連接結構的損傷失效進行瞭研究,分析瞭螺栓連接結構在等效風載壓力和拉力作用下的失效過程和失效彊度,併對天線罩連接結構摺角位置玻璃鋼矇皮的過渡方式對其力學性能的影響進行瞭分析。試驗和數值研究結果錶明,連接結構試件的初始破壞均錶現為玻璃鋼矇皮與泡沫芯材間的層間開裂,初始開裂載荷為0.7倍左右的結構失效載荷,玻璃鋼矇皮採用隔層斷開過渡的加工工藝可顯著提高天線罩連接結構的彊度,數值預測的結構失效彊度與試驗結果吻閤較好。
침대복합재료천선조라전련접결구적손상실효문제,채용시험화점근손상분석방법대복합재료천선조라전련접결구적손상실효진행료연구,분석료라전련접결구재등효풍재압력화랍력작용하적실효과정화실효강도,병대천선조련접결구절각위치파리강몽피적과도방식대기역학성능적영향진행료분석。시험화수치연구결과표명,련접결구시건적초시파배균표현위파리강몽피여포말심재간적층간개렬,초시개렬재하위0.7배좌우적결구실효재하,파리강몽피채용격층단개과도적가공공예가현저제고천선조련접결구적강도,수치예측적결구실효강도여시험결과문합교호。
The failures of the steel?to?composite joints for the radome in ship were researched by using the progres?sive damage analysis and experiments were applied to . A number of studies have been carried out on the structural failure process and static strength of the joints under equivalent wind load and pulling force. The mechanical effect of the transitional way of FRP skin at the angular position of joints structures was analyzed. The tests and numerical study results showed the initial failure modes of all specimens manifest delamination between FRP skin and foam core. The initial failure load equals to 0. 7 times of structural failure load. The experimental investigation verified that transition process of the compartment can significantly increase the strength of the joints of radome. Finite?ele?ment?based progressive damage analyses showed good correlation with experimental results.