CAJ | 학술논문

本文结合CPR1000项目中主控室进风γ剂量率监测通道的设计，通过研究相关法规标准，提出了一种主控室进风空气放射性监测的设计方法。首先对测量对象、设备布置、联锁操作进行了描述，然后利用MCNP软件模拟，建立计算模型，探究了该方法下探测器报警阈值的设定，最后结合计算结果给出了该设计的优缺点和改进思路，具有一定的工程实际应用和参考价值。
본문결합CPR1000항목중주공실진풍γ제량솔감측통도적설계，통과연구상관법규표준，제출료일충주공실진풍공기방사성감측적설계방법。수선대측량대상、설비포치、련쇄조작진행료묘술，연후이용MCNP연건모의，건립계산모형，탐구료해방법하탐측기보경역치적설정，최후결합계산결과급출료해설계적우결점화개진사로，구유일정적공정실제응용화삼고개치。
According to the design of the main control room intake gamma radiation dose rate monitoring channels in CPR1000 project and the study of relevant regulations and standards ,a design method of main control room air inlet radioactive monitoring was presented .The measured object ,equipment layout and chain operation were described . The threshold setting was explored using a calculation model established by MCNP soft‐ware .The advantages ,disadvantages and improvement ideas of this design were pre‐sented on the basis of calculation results .