功能材料
功能材料
공능재료
JOURNAL OF FUNCTIONAL MATERIALS
2012年
14期
1846-1848
,共3页
徐惠%彭振军%卢玉献%邢建伟
徐惠%彭振軍%盧玉獻%邢建偉
서혜%팽진군%로옥헌%형건위
浸渍-水热沉淀法%NiO-CuO%电化学性能
浸漬-水熱沉澱法%NiO-CuO%電化學性能
침지-수열침정법%NiO-CuO%전화학성능
dipping-hydrothermal%NiO-CuO%electrochemical performance
采用浸渍-水热沉淀法合成CuO掺杂Ni(OH)2前驱体,经300℃煅烧得NiO-CuO复合氧化物。利用FT-IR、XRD、SEM和恒流充放电分析测试复合材料的相结构、微观形貌和电化学性能。结果表明,当镍铜比为4∶1时,在5mA/cm2的电流密度下所得复合氧化物单电极比电容为822F/g,180次循环后衰减率仅为4.5%,循环可逆性能好。
採用浸漬-水熱沉澱法閤成CuO摻雜Ni(OH)2前驅體,經300℃煅燒得NiO-CuO複閤氧化物。利用FT-IR、XRD、SEM和恆流充放電分析測試複閤材料的相結構、微觀形貌和電化學性能。結果錶明,噹鎳銅比為4∶1時,在5mA/cm2的電流密度下所得複閤氧化物單電極比電容為822F/g,180次循環後衰減率僅為4.5%,循環可逆性能好。
채용침지-수열침정법합성CuO참잡Ni(OH)2전구체,경300℃단소득NiO-CuO복합양화물。이용FT-IR、XRD、SEM화항류충방전분석측시복합재료적상결구、미관형모화전화학성능。결과표명,당얼동비위4∶1시,재5mA/cm2적전류밀도하소득복합양화물단전겁비전용위822F/g,180차순배후쇠감솔부위4.5%,순배가역성능호。
Nickel hydroxide doped with copper oxide were synthesized by dipping at hydrothermal process.They were annealed in air 300℃ to obtain composite oxide.The samples of phase structure,micro-cosmic morphology and electrochemical properties were characterized by FT-IR,XRD,SEM and constant-current charge-discharge testing techniques.The results showed that the specific capacitance of the NiO-CuO obtained after calcination as a single electrode was up to 822F/g to 5mA/cm2 discharge when nickel copper than for 4∶1.Then the attenuation rate was only 4.5% after 180 cycle.