CAJ | 학술논문

采用40μm球形与无规则形α—Al2O3粒子填充液体硅橡胶，研究了Al2O3粒子用量、形貌对液态灌封胶的粘度与热导率的影响，并用XRD、SEM分析了两种Al2O3的晶型以及在灌封胶中的分布状态。结果表明，在相同的填充量下无规则形Al2O3粒子填充灌封胶的热导率高，球形Al2O3填充灌封胶的可加工性优异。当球形与无规则形填料混合填充的比例为9：1时可以获得最高的热导率，比单一使用球形Al2O3提高了17．1％。
채용40μm구형여무규칙형α—Al2O3입자전충액체규상효，연구료Al2O3입자용량、형모대액태관봉효적점도여열도솔적영향，병용XRD、SEM분석료량충Al2O3적정형이급재관봉효중적분포상태。결과표명，재상동적전충량하무규칙형Al2O3입자전충관봉효적열도솔고，구형Al2O3전충관봉효적가가공성우이。당구형여무규칙형전료혼합전충적비례위9：1시가이획득최고적열도솔，비단일사용구형Al2O3제고료17．1％。
The α-Al2O3 particles with sphericity and irregularity were filled in liquid silicone rubber of which the size is 40μm. The effect of Al2O3 particles amount and morphology on the viscosity and thermal conductivity of liquid encapsulants was studied, meanwhile the crystal form and distribution in the encapsulants of two kinds of alumina was observed by XRD and SEM. The results indicated that the thermal conductivity of liquid encapsu- lants filled with irregular particles was much higher, while the processing performance was rather excellent for sphericity. The thermal conductivity was highest as the ratio of sphericity and irregularity reached 9 ： 1, which increaed by 17.1% compared with the case of only sphericial particles.