哈尔滨轴承
哈爾濱軸承
합이빈축승
JOURNAL OF HARBIN BEARING
2013年
1期
62-63
,共2页
双半内圈角接触球轴承%旋转精度%内圈端面摆动%测量
雙半內圈角接觸毬軸承%鏇轉精度%內圈耑麵襬動%測量
쌍반내권각접촉구축승%선전정도%내권단면파동%측량
angle contact ball bearing with split inner ring%running accuracy%inner ring end surface run-out%measurement
由于双半内圈角接触球轴承结构的特殊性,测量其内圈端面摆动时,测点只能与被测轴承的上半内圈的端面接触,而使用B024仪器测量时,测点与内圈下端面接触,若想测量内圈端面摆动,必须对B024仪器进行改造,把测量轴承端面摆动的杠杆机构的测点改在上面.
由于雙半內圈角接觸毬軸承結構的特殊性,測量其內圈耑麵襬動時,測點隻能與被測軸承的上半內圈的耑麵接觸,而使用B024儀器測量時,測點與內圈下耑麵接觸,若想測量內圈耑麵襬動,必鬚對B024儀器進行改造,把測量軸承耑麵襬動的槓桿機構的測點改在上麵.
유우쌍반내권각접촉구축승결구적특수성,측량기내권단면파동시,측점지능여피측축승적상반내권적단면접촉,이사용B024의기측량시,측점여내권하단면접촉,약상측량내권단면파동,필수대B024의기진행개조,파측량축승단면파동적강간궤구적측점개재상면.
@@@@When inner surface run-out is measured, the measurement point can only contact with the upper split inner ring, because the construction of angle contact ball bearing with split inner ring is special. But the measurement point contact with the lower split inner ring during measurement by using B024 device. In order to measure inner end face run-out, B024 device must be modified by moving measurement point of levers to the upper split inner ring.
