润滑与密封
潤滑與密封
윤활여밀봉
LUBRICATION ENGINEERING
2013年
2期
72-75
,共4页
郑小涛%陈以文%喻九阳%王成刚%林纬
鄭小濤%陳以文%喻九暘%王成剛%林緯
정소도%진이문%유구양%왕성강%림위
自动振打除灰装置%Y型圈%接触应力%动密封
自動振打除灰裝置%Y型圈%接觸應力%動密封
자동진타제회장치%Y형권%접촉응력%동밀봉
automatic rapping-off-ash equipment%Y-ring%contact stress%dynamic seal
采用通用有限元软件ANSYS研究自动振打除灰装置活塞处双Y型密封结构在撞击及回弹状态下的动密封能.结果表明,开始预紧时Y形圈出现预变形,而随后加载的工作压力能缓解局部变形;随着工作流体和氮气压力增大, Y形密封元件接触区内的接触应力也随之增大,且最大接触应力大于双边的流压,满足密封的要求.
採用通用有限元軟件ANSYS研究自動振打除灰裝置活塞處雙Y型密封結構在撞擊及迴彈狀態下的動密封能.結果錶明,開始預緊時Y形圈齣現預變形,而隨後加載的工作壓力能緩解跼部變形;隨著工作流體和氮氣壓力增大, Y形密封元件接觸區內的接觸應力也隨之增大,且最大接觸應力大于雙邊的流壓,滿足密封的要求.
채용통용유한원연건ANSYS연구자동진타제회장치활새처쌍Y형밀봉결구재당격급회탄상태하적동밀봉능.결과표명,개시예긴시Y형권출현예변형,이수후가재적공작압력능완해국부변형;수착공작류체화담기압력증대, Y형밀봉원건접촉구내적접촉응력야수지증대,차최대접촉응력대우쌍변적류압,만족밀봉적요구.
The dynamic seal performances of double Y sealing structures at the piston of automatic rapping-off-ash equipment under rapping and springback conditions were investigated based on general finite element analysis software AN-SYS. Results show that deformation of the Y-type ring is found under the preload case,while the deformation is decreased with the increment of working pressure. Moreover,the contact stress of the Y-type ring is increased when the operating pressure is further increased,and the requirement of the sealing performance can be met due to the maximum contact stress is greater than the inner working pressure.