新乡学院学报(自然科学版)
新鄉學院學報(自然科學版)
신향학원학보(자연과학판)
Journal of Xinxiang University(Natural Science Edition)
2013年
2期
136-138
,共3页
吴亮发%孙宇峰%周超群%孟祥磊
吳亮髮%孫宇峰%週超群%孟祥磊
오량발%손우봉%주초군%맹상뢰
轿车前门三角块%Moldflow%正交试验%极差分析%多指标
轎車前門三角塊%Moldflow%正交試驗%極差分析%多指標
교차전문삼각괴%Moldflow%정교시험%겁차분석%다지표
the front door triangle block%Moldflow%orthogonal experiment%range analysis%multi-index
以轿车前门三角块为研究对象,首先采用Moldflow软件及正交试验方法对其进行模拟试模试验,其次用极差分析法对其结果进行分析,最终得到最佳注射工艺参数组合;同时研究了多指标注射工艺参数对多评价指标的影响.
以轎車前門三角塊為研究對象,首先採用Moldflow軟件及正交試驗方法對其進行模擬試模試驗,其次用極差分析法對其結果進行分析,最終得到最佳註射工藝參數組閤;同時研究瞭多指標註射工藝參數對多評價指標的影響.
이교차전문삼각괴위연구대상,수선채용Moldflow연건급정교시험방법대기진행모의시모시험,기차용겁차분석법대기결과진행분석,최종득도최가주사공예삼수조합;동시연구료다지표주사공예삼수대다평개지표적영향.
Taking car front triangle as the research object, molding trial production simulation test is done firstly with software Moldflow, using orthogonal test method. The results are analyzed by range analysis secondly. And the best injection process parameters combination is obtained finally. Meanwhile, the influences of multi-index injection technological parameters on the multi-index evaluation are studied.
