流体机械
流體機械
류체궤계
FLUID MACHINERY
2014年
11期
73-78
,共6页
宁静红%刘敬坤%刘圣春%诸凯%解海卫
寧靜紅%劉敬坤%劉聖春%諸凱%解海衛
저정홍%류경곤%류골춘%제개%해해위
水蒸汽%水平圆管%冷凝%数值模拟
水蒸汽%水平圓管%冷凝%數值模擬
수증기%수평원관%냉응%수치모의
vapor%horizontal tubes%condensation%numerical simulation
对水蒸汽在内径为8 mm的水平圆管内,不同管壁温度、蒸汽流速、压力和入口过热度下的冷凝过程,采用通用CFD软件Fluent 13.0中的Mixture模型,结合UDF编程对水平管内冷凝物理模型进行数值模拟。通过分析相应的冷凝液分布云图、体积分数和局部换热系数的变化曲线,得出蒸汽在水平管内冷凝换热系数与壁温、蒸汽流速、压力和入口过热度的变化规律。并将模拟结果与实验测试结果进行了对比,得出模拟结果比计算值偏高约30%。
對水蒸汽在內徑為8 mm的水平圓管內,不同管壁溫度、蒸汽流速、壓力和入口過熱度下的冷凝過程,採用通用CFD軟件Fluent 13.0中的Mixture模型,結閤UDF編程對水平管內冷凝物理模型進行數值模擬。通過分析相應的冷凝液分佈雲圖、體積分數和跼部換熱繫數的變化麯線,得齣蒸汽在水平管內冷凝換熱繫數與壁溫、蒸汽流速、壓力和入口過熱度的變化規律。併將模擬結果與實驗測試結果進行瞭對比,得齣模擬結果比計算值偏高約30%。
대수증기재내경위8 mm적수평원관내,불동관벽온도、증기류속、압력화입구과열도하적냉응과정,채용통용CFD연건Fluent 13.0중적Mixture모형,결합UDF편정대수평관내냉응물리모형진행수치모의。통과분석상응적냉응액분포운도、체적분수화국부환열계수적변화곡선,득출증기재수평관내냉응환열계수여벽온、증기류속、압력화입구과열도적변화규률。병장모의결과여실험측시결과진행료대비,득출모의결과비계산치편고약30%。
By adopting the Mixture Model in CFD software Fluent 13.0 combined with UDF procedure,the numerical simulation was carried out that water vapor condensates inside horizontal tubes which diameter is 8 mm,under different wall temperatures,va-por velocities,pressures and inlet superheats.By analyzing the condensation liquid contour,void fraction and local heat transfer coefficient at different points,the rules are obtained that the condensation heat transfer coefficient changes with the wall tempera-tures,vapor velocities,pressures and inlet superheats.The comparison is done between the simulation result and the experimental results and it shows that the simulation value is larger than the experimental one by 30%.