化工技术与开发
化工技術與開髮
화공기술여개발
TECHNOLOGY & DVELOPMENT OF CHEMICAL INDUSTRY
2014年
12期
22-25
,共4页
聚酯材料%化学镀%敏化%活化
聚酯材料%化學鍍%敏化%活化
취지재료%화학도%민화%활화
polyester material%electroless nickle plating%sensitization%activation
研究了聚酯材料表面化学镀镍的实验操作方法、工艺控制条件，讨论了各种因素对镀层质量的影响，确定了聚酯材料表面化学镀镍的工艺流程和最佳实验条件。实验结果表明，聚酯材料经过预处理及敏化、活化处理后，化学镀镍溶液的pH值控制在5.5，镀镍温度在45℃，反应时间25min，可以得到较好的聚酯材料化学镀镍镀层。
研究瞭聚酯材料錶麵化學鍍鎳的實驗操作方法、工藝控製條件，討論瞭各種因素對鍍層質量的影響，確定瞭聚酯材料錶麵化學鍍鎳的工藝流程和最佳實驗條件。實驗結果錶明，聚酯材料經過預處理及敏化、活化處理後，化學鍍鎳溶液的pH值控製在5.5，鍍鎳溫度在45℃，反應時間25min，可以得到較好的聚酯材料化學鍍鎳鍍層。
연구료취지재료표면화학도얼적실험조작방법、공예공제조건，토론료각충인소대도층질량적영향，학정료취지재료표면화학도얼적공예류정화최가실험조건。실험결과표명，취지재료경과예처리급민화、활화처리후，화학도얼용액적pH치공제재5.5，도얼온도재45℃，반응시간25min，가이득도교호적취지재료화학도얼도층。
The operating methods and condition of electroless nickel plating on surface of the polyester material were studied,influ-ence factors of nickel-plating on the surface of the polyester material were discussed.Then the combination strength between chemi-cal coating and polyester material was tested,the best process and optimum conditons were finally determined. The results showed that the optimum conditions were as followed:pH=5.5,the nickel plating temperature 45℃and the reaction time 10~20min. Under the above conditions,good nickel-plating coating on surface polyester material after pretreatment,sensitization and activation could be gained.
