新技术新工艺
新技術新工藝
신기술신공예
NEW TECHNOLOGY & NEW PROCESS
2014年
12期
98-100,101
,共4页
黄晓锋%郝翠翠%冯凯%李兴鹏%刘玉凤
黃曉鋒%郝翠翠%馮凱%李興鵬%劉玉鳳
황효봉%학취취%풍개%리흥붕%류옥봉
镁合金%半固态%Zn含量%显微组织%力学性能
鎂閤金%半固態%Zn含量%顯微組織%力學性能
미합금%반고태%Zn함량%현미조직%역학성능
magnesium alloy%semi-solid%Zn content%microstructure%mechanical properties
通过光学显微镜、扫描电镜和万能力学试验机等设备研究了 Zn含量对镁合金铸态和半固态显微组织变化的影响。研究表明,随着Zn 含量的增加,合金的铸态显微组织得到了细化,合金的半固态组织的晶粒明显细小、圆整。当等温热处理温度为570℃、保温时间为30 min 时,半固态显微组织最好,其中,Mg-9Al-1Zn合金的颗粒尺寸为74μm,Mg-9Al-3Zn合金的颗粒尺寸为68μm,Mg-9Al-5Zn合金的颗粒尺寸为57μm。
通過光學顯微鏡、掃描電鏡和萬能力學試驗機等設備研究瞭 Zn含量對鎂閤金鑄態和半固態顯微組織變化的影響。研究錶明,隨著Zn 含量的增加,閤金的鑄態顯微組織得到瞭細化,閤金的半固態組織的晶粒明顯細小、圓整。噹等溫熱處理溫度為570℃、保溫時間為30 min 時,半固態顯微組織最好,其中,Mg-9Al-1Zn閤金的顆粒呎吋為74μm,Mg-9Al-3Zn閤金的顆粒呎吋為68μm,Mg-9Al-5Zn閤金的顆粒呎吋為57μm。
통과광학현미경、소묘전경화만능역학시험궤등설비연구료 Zn함량대미합금주태화반고태현미조직변화적영향。연구표명,수착Zn 함량적증가,합금적주태현미조직득도료세화,합금적반고태조직적정립명현세소、원정。당등온열처리온도위570℃、보온시간위30 min 시,반고태현미조직최호,기중,Mg-9Al-1Zn합금적과립척촌위74μm,Mg-9Al-3Zn합금적과립척촌위68μm,Mg-9Al-5Zn합금적과립척촌위57μm。
The effects of Zn content on the alloy cast and semi-solid microstructure were studied by the optical microsco-py,scanning electron microscopy,mechanical universal testing machines and other equipments.Research results showed that with increasing of Zn content,cast alloy microstructure has been refined to further.Semi-solid alloy crystal ball of tis-sue was significantly small and rounding.When isothermal heat treatment temperature reaches 570 ℃ and holding time is in the 30 min,semi-solid micro-structure is the best.The particle size of Mg-9Al-1Zn is 74.39μm,the particle size of Mg-9Al-3Zn is 68.12μm and the particle size of Mg-9Al-5Zn is 57.34μm.