陕西科技大学学报(自然科学版)
陝西科技大學學報(自然科學版)
협서과기대학학보(자연과학판)
JOURNAL OF SHAANXI UNIVERSITY OF SCIENCE & TECHNOLOGY
2015年
1期
103-107
,共5页
陈晓明%廖新维%赵晓亮%崔灿%叶恒%王牧
陳曉明%廖新維%趙曉亮%崔燦%葉恆%王牧
진효명%료신유%조효량%최찬%협항%왕목
CO2 驱%回注气%最小混相压力%驱油效率%油藏数值模拟
CO2 驅%迴註氣%最小混相壓力%驅油效率%油藏數值模擬
CO2 구%회주기%최소혼상압력%구유효솔%유장수치모의
CO2 flooding%gas reinjection%MMP%sweep efficiency%numerical reservoir simu-lation
国内部分油田进入了三次采油期。采用CO2驱油提高采收率,具有低碳环保、经济高效等优势,已经得到了推广应用。回注气驱油技术作为CO2驱替技术的一个延伸,其组分的确定对矿场提高采收率具有十分重要的意义。本文针对松辽盆地的油藏特征,进行了细管实验分析和数值模拟研究,分析了回注气组成对最小混相压力的影响以及不同CO2纯度下的驱油效率特征。同时,应用油藏工程方法,确定了回注气提高采收率的工程技术指标,为矿场回注气的高效开发提供技术参考。实验分析和数值模拟结果均表明,黑59区块回注气C O 2浓度比例不低于93%时,驱油效果最佳。
國內部分油田進入瞭三次採油期。採用CO2驅油提高採收率,具有低碳環保、經濟高效等優勢,已經得到瞭推廣應用。迴註氣驅油技術作為CO2驅替技術的一箇延伸,其組分的確定對礦場提高採收率具有十分重要的意義。本文針對鬆遼盆地的油藏特徵,進行瞭細管實驗分析和數值模擬研究,分析瞭迴註氣組成對最小混相壓力的影響以及不同CO2純度下的驅油效率特徵。同時,應用油藏工程方法,確定瞭迴註氣提高採收率的工程技術指標,為礦場迴註氣的高效開髮提供技術參攷。實驗分析和數值模擬結果均錶明,黑59區塊迴註氣C O 2濃度比例不低于93%時,驅油效果最佳。
국내부분유전진입료삼차채유기。채용CO2구유제고채수솔,구유저탄배보、경제고효등우세,이경득도료추엄응용。회주기구유기술작위CO2구체기술적일개연신,기조분적학정대광장제고채수솔구유십분중요적의의。본문침대송료분지적유장특정,진행료세관실험분석화수치모의연구,분석료회주기조성대최소혼상압력적영향이급불동CO2순도하적구유효솔특정。동시,응용유장공정방법,학정료회주기제고채수솔적공정기술지표,위광장회주기적고효개발제공기술삼고。실험분석화수치모의결과균표명,흑59구괴회주기C O 2농도비례불저우93%시,구유효과최가。
Some of domestic oil fields are in the tertiary EOR phase .Carbon dioxide drive is an environmental friendly ,low carbon emission and high economic efficiency EOR method .The technique of gas reinjection ,as extension of Carbon dioxide drive tech ,the determination of the components is of great significance to the field oil recovery′s improvement .According to Song Liao Basin′s reservoir characteristics ,methods of experimental analysis and theoretical studies were combined .Phase behavior of reinjection gas was studied .Reinjection gas compo‐sition′s impact on the minimum miscibility pressure (MMP) was analyzed .Oil displacement efficiency characteristics under different CO2 purity were researched .Technical indicators of gas injection EOR were determined through combination of reservoir engineering and numer‐ical simulation methods .The result shows that when the concentration ratio of CO2 in rein‐jection gas is greater than 93% ,HEI‐59 reaches an optimal displacement characteristics .