食品安全质量检测学报
食品安全質量檢測學報
식품안전질량검측학보
FOOD SAFETY AND QUALITY DETECTION TECHNOLOGY
2014年
12期
3870-3874
,共5页
郝鹏飞%刘东风%孟慧琴%吕宁%徐琴%王延飞
郝鵬飛%劉東風%孟慧琴%呂寧%徐琴%王延飛
학붕비%류동풍%맹혜금%려저%서금%왕연비
生湿面制品%乙二醇%丙二醇%气相色谱法
生濕麵製品%乙二醇%丙二醇%氣相色譜法
생습면제품%을이순%병이순%기상색보법
wet flour products%ethylene glycol%propanediol%gas chromatography
目的:建立对生湿面制品中乙二醇、1,2-丙二醇和1,3-丙二醇含量同时测定的气相色谱方法。方法样品经粉碎,加适量的海砂研磨成干粉状,加入无水乙醇提取,离心,过滤后用气相色谱测定其中乙二醇、1,2-丙二醇和1,3-丙二醇的含量。采用石英毛细管色谱柱(HP-INNOWAX),进样口为240℃,分流比为20:1,流速为1.0 mL/min,程序升温为:初始100℃,维持4 min,再以50℃/min升温至200℃,维持8 min。检测器为氢火焰离子化检测器(FID),检测器温度为280℃。结果该方法在2.39~2500μg/mL浓度范围内呈良好的线性关系,R2>0.9993,检出限为0.72~0.87 mg/kg。在5.0、10.0、50.0 mg/kg三个添加水平下,平均回收率为87%~106%(n=6),相对标准偏差(RSD)为1.3%~5.4%(n=6)。结论该方法简便、快速、灵敏度好、准确度高,所使用的试剂毒性小,可同时检测大量样品,能满足实际样品的检测要求。
目的:建立對生濕麵製品中乙二醇、1,2-丙二醇和1,3-丙二醇含量同時測定的氣相色譜方法。方法樣品經粉碎,加適量的海砂研磨成榦粉狀,加入無水乙醇提取,離心,過濾後用氣相色譜測定其中乙二醇、1,2-丙二醇和1,3-丙二醇的含量。採用石英毛細管色譜柱(HP-INNOWAX),進樣口為240℃,分流比為20:1,流速為1.0 mL/min,程序升溫為:初始100℃,維持4 min,再以50℃/min升溫至200℃,維持8 min。檢測器為氫火燄離子化檢測器(FID),檢測器溫度為280℃。結果該方法在2.39~2500μg/mL濃度範圍內呈良好的線性關繫,R2>0.9993,檢齣限為0.72~0.87 mg/kg。在5.0、10.0、50.0 mg/kg三箇添加水平下,平均迴收率為87%~106%(n=6),相對標準偏差(RSD)為1.3%~5.4%(n=6)。結論該方法簡便、快速、靈敏度好、準確度高,所使用的試劑毒性小,可同時檢測大量樣品,能滿足實際樣品的檢測要求。
목적:건립대생습면제품중을이순、1,2-병이순화1,3-병이순함량동시측정적기상색보방법。방법양품경분쇄,가괄량적해사연마성간분상,가입무수을순제취,리심,과려후용기상색보측정기중을이순、1,2-병이순화1,3-병이순적함량。채용석영모세관색보주(HP-INNOWAX),진양구위240℃,분류비위20:1,류속위1.0 mL/min,정서승온위:초시100℃,유지4 min,재이50℃/min승온지200℃,유지8 min。검측기위경화염리자화검측기(FID),검측기온도위280℃。결과해방법재2.39~2500μg/mL농도범위내정량호적선성관계,R2>0.9993,검출한위0.72~0.87 mg/kg。재5.0、10.0、50.0 mg/kg삼개첨가수평하,평균회수솔위87%~106%(n=6),상대표준편차(RSD)위1.3%~5.4%(n=6)。결론해방법간편、쾌속、령민도호、준학도고,소사용적시제독성소,가동시검측대량양품,능만족실제양품적검측요구。
Objective To establish a method of simultaneous determination of ethylene-glycol, 1,2- propanediol and 1,3-propanediol in wet flour products by gas chromatography.Methods The sample was shattered, ground into dry powder by adding proper amount of sea sands, extracted by anhydrous ethanol, and centrifuged, filtered, and detected the content of ethylene glycol, 1,2-propanediol and 1,3-propanediol by gas chromatography. By using silica capillary chromatography column (HP-INNOWAX), the temperature of the injection port was 240℃, the split ratio was 20:1, the flow rate was 1.0 mL/min, the programmed temperature was as follows: maintaining 100℃ for 4 min, and raising temperature to 200℃ at the rate of 50℃/min, then maintaining 8 min. The detector was hydrogen flame ionization detector and its temperature was 280℃. Results The method showed a good linearity over the range of 2.39~2500 μg/mL,R2>0.9993, the detection limit was 0.72~0.87 mg/kg, the average recoveries were 87%~106% (n=6) and the relative standard derivations (RSD) were 1.3%~5.4% (n=6).Conclusion This method is simple, rapid, sensitive and accurate, and the reagents used have low toxicity, and it can test large quantity of samples simultaneously and satisfy the requirement of practical samples.