广东工业大学学报
廣東工業大學學報
엄동공업대학학보
JOURNAL OF GUANGDONG UNIVERSITY OF TECHNOLOGY
2014年
4期
95-99
,共5页
背光源%网点设计%侧入式
揹光源%網點設計%側入式
배광원%망점설계%측입식
backlight%design of scattering netter dots%side-incident
选取LED作为侧入式导光板光源,利用光的全反射、折射和光通量守恒定律等光学理论推导出变距离(网点大小相同)网点的排布规律,有效解决了网点的设计难题。同时推导出LED排列间距临界公式,有效消除了由LED的排列间距引起的强弱光区交替现象。通过光学软件TracePro,建立相应的物理模型。经过反复实验,取得最佳参数,均匀度高达93%,超过80%,满足实际对均匀性的要求。
選取LED作為側入式導光闆光源,利用光的全反射、摺射和光通量守恆定律等光學理論推導齣變距離(網點大小相同)網點的排佈規律,有效解決瞭網點的設計難題。同時推導齣LED排列間距臨界公式,有效消除瞭由LED的排列間距引起的彊弱光區交替現象。通過光學軟件TracePro,建立相應的物理模型。經過反複實驗,取得最佳參數,均勻度高達93%,超過80%,滿足實際對均勻性的要求。
선취LED작위측입식도광판광원,이용광적전반사、절사화광통량수항정률등광학이론추도출변거리(망점대소상동)망점적배포규률,유효해결료망점적설계난제。동시추도출LED배렬간거림계공식,유효소제료유LED적배렬간거인기적강약광구교체현상。통과광학연건TracePro,건립상응적물리모형。경과반복실험,취득최가삼수,균균도고체93%,초과80%,만족실제대균균성적요구。
With LED selected as the light source of side-incident light guide plates, it solves the difficult problems with the design of scattering netted dots with various distances on light guide plates of side-inci-dent LED backlight efficiently by deriving a rule of scattering netted dots arrangement, based on the op-tics theories such as total reflection, refraction and the principle of luminous flux conservation.The criti-cal array pitch of LED is deduced, which can effectively eliminate the different light intensity caused by LED arrays.Then, the optical design software TracePro was used to establish the physical simulation model.Through repeated experimental investigation, optimum parameters have been obtained.The simu-lation results show that the illumination uniformity of the designed light guide plate is close to 93%( over 80%) , which satisfies the requirements of the national illumination standard.