合成材料老化与应用
閤成材料老化與應用
합성재료노화여응용
SYNTHETIC MATERIALS AGING AND APPLICATION
2015年
1期
67-70
,共4页
余钱红%牟婉君%谢翔%李兴亮%张锐%魏洪源
餘錢紅%牟婉君%謝翔%李興亮%張銳%魏洪源
여전홍%모완군%사상%리흥량%장예%위홍원
钽%水热法%光吸收性能
鐽%水熱法%光吸收性能
단%수열법%광흡수성능
tantalum%hydrothermal method%optical absorption properties
以TaCl5和Na2 WO4为原料,采用水热法在170℃保温6h~48h合成钽掺杂球形氧化钨。利用XRD、SEM等手段对产物进行物相、形貌表征。研究表明:水热反应时间为6 h~48 h均能获得三斜晶型的氧化钨球,球体尺寸在200 nm~350 nm之间。对不同反应时间条件下合成的氧化钨球进行紫外-可见光的吸收光谱分析可知,随着反应时间的增加,获得钽掺杂氧化钨样品对光的吸收能力增强,平均禁带宽度为3.72 eV。
以TaCl5和Na2 WO4為原料,採用水熱法在170℃保溫6h~48h閤成鐽摻雜毬形氧化鎢。利用XRD、SEM等手段對產物進行物相、形貌錶徵。研究錶明:水熱反應時間為6 h~48 h均能穫得三斜晶型的氧化鎢毬,毬體呎吋在200 nm~350 nm之間。對不同反應時間條件下閤成的氧化鎢毬進行紫外-可見光的吸收光譜分析可知,隨著反應時間的增加,穫得鐽摻雜氧化鎢樣品對光的吸收能力增彊,平均禁帶寬度為3.72 eV。
이TaCl5화Na2 WO4위원료,채용수열법재170℃보온6h~48h합성단참잡구형양화오。이용XRD、SEM등수단대산물진행물상、형모표정。연구표명:수열반응시간위6 h~48 h균능획득삼사정형적양화오구,구체척촌재200 nm~350 nm지간。대불동반응시간조건하합성적양화오구진행자외-가견광적흡수광보분석가지,수착반응시간적증가,획득단참잡양화오양품대광적흡수능력증강,평균금대관도위3.72 eV。
Global tungsten oxide doped with tantalum were synthesized by a facile hydrothermal method using TaCl5 and Na2 WO4 as raw materials at 170℃ for 6h ~48h. The samples of the products were characterized by XRD,SEM and IR. The results showed that the global tungsten oxide powders with the pure triclinic phase in the grain size range from 200 to 350 nm can be synthesized at 6 h~48 h at 170℃. The optical absorption preoperties of the samples were characterized by UV-VIS. As the reaction time increasing,the optical absorption of synthesized global tungsten oxide doped with addition of tantalum increased gradually,and the average band gap was 3. 72eV.