山东医药
山東醫藥
산동의약
SHANDONG MEDICAL JOURNAL
2015年
7期
11-13
,共3页
杨金有%王艳%刘静%俞航%洪洋
楊金有%王豔%劉靜%俞航%洪洋
양금유%왕염%류정%유항%홍양
支架%再狭窄%壁面切应力%计算流体力学%血流动力学
支架%再狹窄%壁麵切應力%計算流體力學%血流動力學
지가%재협착%벽면절응력%계산류체역학%혈류동역학
stents%restenosis%wall shear stress%computational fluid dynamics%hemodynamics
目的:观察植入V形支架并已经扩张稳定的人体降主动脉处的血流动力学指标,探讨支架植入的多少与远端支架处出现血管再狭窄的关系。方法获取1例动脉瘤患者覆膜V形支架植入术后复查的增强CT图像数据,以Dicom格式输入医学图像后处理软件,应用逆向工程方法三维重构主动脉血管和V形血管支架,在设定边界条件和初始条件的基础上,应用ANSYS模拟软件经多次迭代计算,获得血管壁面切应力、壁面振荡切应力和支架横截面血流速度矢量等相关血流动力学参数。结果由近及远,支架处的壁面切应力最大值逐渐降低,分别为3.56、3.26和2.48 Pa,而壁面振荡剪切指数平均值则相反,分别为0.002140、0.005677和0.010852。在心动收缩峰值期(0.08 s),3个支架横截面处的血流速度均较大,方向多变并对支架有较大冲击,而在心动收缩末期和舒张期血流速度减缓,但与支架相接触处血流速度仍较高,并在舒张期出现明显的涡流。结论支架植入越多,降主动脉远端处支架的壁面切应力值越低,壁面振荡剪切指数值越高,且支架横截面的血流速度矢量越复杂,出现血管再狭窄的概率越大。
目的:觀察植入V形支架併已經擴張穩定的人體降主動脈處的血流動力學指標,探討支架植入的多少與遠耑支架處齣現血管再狹窄的關繫。方法穫取1例動脈瘤患者覆膜V形支架植入術後複查的增彊CT圖像數據,以Dicom格式輸入醫學圖像後處理軟件,應用逆嚮工程方法三維重構主動脈血管和V形血管支架,在設定邊界條件和初始條件的基礎上,應用ANSYS模擬軟件經多次迭代計算,穫得血管壁麵切應力、壁麵振盪切應力和支架橫截麵血流速度矢量等相關血流動力學參數。結果由近及遠,支架處的壁麵切應力最大值逐漸降低,分彆為3.56、3.26和2.48 Pa,而壁麵振盪剪切指數平均值則相反,分彆為0.002140、0.005677和0.010852。在心動收縮峰值期(0.08 s),3箇支架橫截麵處的血流速度均較大,方嚮多變併對支架有較大遲擊,而在心動收縮末期和舒張期血流速度減緩,但與支架相接觸處血流速度仍較高,併在舒張期齣現明顯的渦流。結論支架植入越多,降主動脈遠耑處支架的壁麵切應力值越低,壁麵振盪剪切指數值越高,且支架橫截麵的血流速度矢量越複雜,齣現血管再狹窄的概率越大。
목적:관찰식입V형지가병이경확장은정적인체강주동맥처적혈류동역학지표,탐토지가식입적다소여원단지가처출현혈관재협착적관계。방법획취1례동맥류환자복막V형지가식입술후복사적증강CT도상수거,이Dicom격식수입의학도상후처리연건,응용역향공정방법삼유중구주동맥혈관화V형혈관지가,재설정변계조건화초시조건적기출상,응용ANSYS모의연건경다차질대계산,획득혈관벽면절응력、벽면진탕절응력화지가횡절면혈류속도시량등상관혈류동역학삼수。결과유근급원,지가처적벽면절응력최대치축점강저,분별위3.56、3.26화2.48 Pa,이벽면진탕전절지수평균치칙상반,분별위0.002140、0.005677화0.010852。재심동수축봉치기(0.08 s),3개지가횡절면처적혈류속도균교대,방향다변병대지가유교대충격,이재심동수축말기화서장기혈류속도감완,단여지가상접촉처혈류속도잉교고,병재서장기출현명현적와류。결론지가식입월다,강주동맥원단처지가적벽면절응력치월저,벽면진탕전절지수치월고,차지가횡절면적혈류속도시량월복잡,출현혈관재협착적개솔월대。
Objective To observe the hemodynamic parameters of the descending aorta with expanded V-shaped stent implantation , and to investigate the relationships between the stent number and vascular restenosis in the distal stents . Methods The enhanced CT image of the descending aorta with the V-shaped stents implanted was input into the medical image processing software with Dicom format , and the three-dimensional reconstruction model of aortic and stent was recon-structed by reverse engineering methods .On the basis of setting the boundary condition and initial condition , the vascular wall shear stress , wall oscillation shear stress , stent cross section flow velocity vector and other related hemodynamic pa-rameters were obtained with the application of ANSYS simulation software after several times of iterative calculation .Re-sults From the near to the distant , the wall shear stress values on the different positions were 3.56 Pa, 3.26Pa and 3.26 Pa, and the average values of oscillating shear index were 0.002 140, 0.005 677 and 0.010 852, respectively.In the sys-tolic peak period (0.08 s), the blood flow velocities of the cross sections of three stents were larger with changeable direc -tions and had a great impact on the stent .While in the end-systolic and diastolic period , the flow velocity was slow down , but the flow velocity was still high in the contact point , and the eddy current was obvious in the diastolic phase .Conclu-sion With the stent increases , the wall shear stress value of the descending aorta decreases in the distal end but the wall oscillatory shear index value increases , meanwhile, the blood flow velocity vector of the stent cross section becomes more complex, and the risk of vascular restenosis increases .