湘潭大学自然科学学报
湘潭大學自然科學學報
상담대학자연과학학보
NATURAL SCIENCE JOURNAL OF XIANGTAN UNIVERSITY
2014年
4期
10-14
,共5页
喻更生%罗勉%彭伟%李壮
喻更生%囉勉%彭偉%李壯
유경생%라면%팽위%리장
非晶态合金%硬度%压力敏感%自由体积
非晶態閤金%硬度%壓力敏感%自由體積
비정태합금%경도%압력민감%자유체적
bulk metallic glass%hardness%pressure sensitivity%free volume
采用压痕法对铸态及退火态的Zr41.2 Ti13.8 Cu12.5 Ni10 Be22.5和Zr65 Al7.5 Cu17.5 Ni10非晶态合金的显微硬度进行了测试.研究发现,在压痕测试中,当外载荷为0.3~20 kg时,Zr基非晶态合金硬度值在小载荷条件下显著增加,而当载荷达到一定值之后,其硬度值缓慢增加最后趋于定值;在523~633 K温度范围内,经退火处理的Zr基非晶态合金的硬度值高于铸态合金,而且随着退火温度的升高,其硬度值增加;研究结果表明非晶态合金为压应力敏感材料,并讨论了压力敏感因子与非晶态合金硬度之间的关系.
採用壓痕法對鑄態及退火態的Zr41.2 Ti13.8 Cu12.5 Ni10 Be22.5和Zr65 Al7.5 Cu17.5 Ni10非晶態閤金的顯微硬度進行瞭測試.研究髮現,在壓痕測試中,噹外載荷為0.3~20 kg時,Zr基非晶態閤金硬度值在小載荷條件下顯著增加,而噹載荷達到一定值之後,其硬度值緩慢增加最後趨于定值;在523~633 K溫度範圍內,經退火處理的Zr基非晶態閤金的硬度值高于鑄態閤金,而且隨著退火溫度的升高,其硬度值增加;研究結果錶明非晶態閤金為壓應力敏感材料,併討論瞭壓力敏感因子與非晶態閤金硬度之間的關繫.
채용압흔법대주태급퇴화태적Zr41.2 Ti13.8 Cu12.5 Ni10 Be22.5화Zr65 Al7.5 Cu17.5 Ni10비정태합금적현미경도진행료측시.연구발현,재압흔측시중,당외재하위0.3~20 kg시,Zr기비정태합금경도치재소재하조건하현저증가,이당재하체도일정치지후,기경도치완만증가최후추우정치;재523~633 K온도범위내,경퇴화처리적Zr기비정태합금적경도치고우주태합금,이차수착퇴화온도적승고,기경도치증가;연구결과표명비정태합금위압응력민감재료,병토론료압력민감인자여비정태합금경도지간적관계.
The microhardness of the as-cast and annealed Zr41.2 Ti13.8 Cu12.5 Ni10 Be22.5 and Zr65 Al7.5 Cu17.5 Ni10 bulk metallic glasses (BMGs)were measured though the Vickers indentation tests.It was found that,under the applying load in the range of 0.3~20 kg,the microhardness of the BMGs increased significantly with the load at low degree.As the load increased to a certain degree,the microhardness of the BMGs increases slowly and finally achieve a constant value.Moreover,the microhardness of the BMGs increases with in-creasing annealing temperature.The results indicate that the BMGs are pressure sensitivity materials,and the changes of the microhardness with the applying load and the annealing temperatures are discussed on the pressure sensitivity index of Zr-based BMGs.