催化学报
催化學報
최화학보
CHINESE JOURNAL OF CATALYSIS
2015年
2期
188-196
,共9页
甲醛%铂%二氧化钛%原位红外光谱%沉积-沉淀法
甲醛%鉑%二氧化鈦%原位紅外光譜%沉積-沉澱法
갑철%박%이양화태%원위홍외광보%침적-침정법
Formaldehyde%Platinum%Titanium In-situ diffuse reflectance infrared%Fourier transform spectroscopy%Deposition-precipitation
通过浸渍法(IM)和沉积-沉淀(DP)法制备了一系列Pt/TiO2(P25)催化剂,并分别用甲醛溶液和氢气还原处理催化剂.利用原位红外监测催化剂表面吸附物种在反应过程中的变化,探究了催化剂制备和还原条件及Pt负载量对催化剂结构和催化氧化甲醛活性的影响.结果显示,用DP法制备并用甲醛还原的Pt/P25催化剂中Pt颗粒分散均匀,并具有合适的粒径和高浓度的表面活性氧,显示出良好的甲醛氧化活性.在空速30000 ml/(g·h)、反应温度30°C和甲醛初始浓度50 mg/m3的条件下,0.4%Pt/P25(DP-HCHO)上的甲醛转化率达到98%,并能稳定运行100 h以上.相比之下, Pt/P25(DP-H2)由于表面活性氧较少,不利于甲酸盐氧化,活性较低. Pt/P25(IM-H2)虽然具有高浓度的表面活性氧,却同时具有最大的Pt颗粒粒径,在甲醛转化为甲酸盐和甲酸盐氧化两步反应中的活性均较差,因而甲醛氧化活性最差.
通過浸漬法(IM)和沉積-沉澱(DP)法製備瞭一繫列Pt/TiO2(P25)催化劑,併分彆用甲醛溶液和氫氣還原處理催化劑.利用原位紅外鑑測催化劑錶麵吸附物種在反應過程中的變化,探究瞭催化劑製備和還原條件及Pt負載量對催化劑結構和催化氧化甲醛活性的影響.結果顯示,用DP法製備併用甲醛還原的Pt/P25催化劑中Pt顆粒分散均勻,併具有閤適的粒徑和高濃度的錶麵活性氧,顯示齣良好的甲醛氧化活性.在空速30000 ml/(g·h)、反應溫度30°C和甲醛初始濃度50 mg/m3的條件下,0.4%Pt/P25(DP-HCHO)上的甲醛轉化率達到98%,併能穩定運行100 h以上.相比之下, Pt/P25(DP-H2)由于錶麵活性氧較少,不利于甲痠鹽氧化,活性較低. Pt/P25(IM-H2)雖然具有高濃度的錶麵活性氧,卻同時具有最大的Pt顆粒粒徑,在甲醛轉化為甲痠鹽和甲痠鹽氧化兩步反應中的活性均較差,因而甲醛氧化活性最差.
통과침지법(IM)화침적-침정(DP)법제비료일계렬Pt/TiO2(P25)최화제,병분별용갑철용액화경기환원처리최화제.이용원위홍외감측최화제표면흡부물충재반응과정중적변화,탐구료최화제제비화환원조건급Pt부재량대최화제결구화최화양화갑철활성적영향.결과현시,용DP법제비병용갑철환원적Pt/P25최화제중Pt과립분산균균,병구유합괄적립경화고농도적표면활성양,현시출량호적갑철양화활성.재공속30000 ml/(g·h)、반응온도30°C화갑철초시농도50 mg/m3적조건하,0.4%Pt/P25(DP-HCHO)상적갑철전화솔체도98%,병능은정운행100 h이상.상비지하, Pt/P25(DP-H2)유우표면활성양교소,불리우갑산염양화,활성교저. Pt/P25(IM-H2)수연구유고농도적표면활성양,각동시구유최대적Pt과립립경,재갑철전화위갑산염화갑산염양화량보반응중적활성균교차,인이갑철양화활성최차.
A series of Pt/TiO2(P25) catalysts were prepared by both impregnation (IM) and deposi‐tion‐precipitation (DP) methods followed by reduction using either a HCHO solution or a H2 stream. The effects of the preparation and reduction conditions and the Pt loading level on structural prop‐erties and performance during HCHO oxidation were then studied based on the assessment of ad‐sorbed species on the catalyst surfaces using in‐situ diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS). The results indicated that Pt/P25 prepared by DP and reduced with HCHO exhibited homogeneously dispersed Pt nanoparticles with appropriate particle size in addition to a high concentration of chemisorbed oxygen, and also showed high activity for HCHO oxidation. A HCHO conversion of 98%with stable performance over more than 100 h was achieved over Pt/P25 produced using DP and HCHO reduction at 30 °C, even with a 0.4%Pt loading. Pt/P25 synthesized using DP with H2 reduction was less effective at promoting formate decomposition and thus showed less HCHO oxidation activity, likely because of lower levels of chemisorbed oxygen. The Pt/P25 made using IM and H2 reduction had the highest amount of chemisorbed oxygen but also the largest Pt particles, resulting in the lowest activity for both the formation of formate species and formate decomposition into CO species, and thus showed low HCHO oxidation activity.