工业水处理
工業水處理
공업수처리
INDUSTRIAL WATER TREATMENT
2015年
4期
41-44,52
,共5页
刘岩%刘东方%高芳%王浩%王艺%李斯施
劉巖%劉東方%高芳%王浩%王藝%李斯施
류암%류동방%고방%왕호%왕예%리사시
三元驱%特种产酸酵母%水解酸化%膜生物反应器
三元驅%特種產痠酵母%水解痠化%膜生物反應器
삼원구%특충산산효모%수해산화%막생물반응기
ASP%special acid-producing yeast%hydrolysis acidification%membrane bioreactor
为解决油田三元驱采出水的回注问题，采用特种产酸酵母预处理与活性污泥的水解酸化—MBR组合工艺对采出水进行处理。结果表明，在酵母菌污泥质量浓度（MLSS）为5000 mg/L、外加碳源1.5 g/L、反应时间3 h的条件下，酵母菌预处理效果最佳；当进水COD为1710 mg/L、聚丙烯酰胺（PAM）为92 mg/L、含油74 mg/L时，处理系统对废水COD、PAM及油的去除率分别达到76.4%、95.0%、89.1%，中位粒径稳定在0.14μm，悬浮物降至1.2 mg/L；出水可达到SY/T 5329—2012中的渗透层注水标准。
為解決油田三元驅採齣水的迴註問題，採用特種產痠酵母預處理與活性汙泥的水解痠化—MBR組閤工藝對採齣水進行處理。結果錶明，在酵母菌汙泥質量濃度（MLSS）為5000 mg/L、外加碳源1.5 g/L、反應時間3 h的條件下，酵母菌預處理效果最佳；噹進水COD為1710 mg/L、聚丙烯酰胺（PAM）為92 mg/L、含油74 mg/L時，處理繫統對廢水COD、PAM及油的去除率分彆達到76.4%、95.0%、89.1%，中位粒徑穩定在0.14μm，懸浮物降至1.2 mg/L；齣水可達到SY/T 5329—2012中的滲透層註水標準。
위해결유전삼원구채출수적회주문제，채용특충산산효모예처리여활성오니적수해산화—MBR조합공예대채출수진행처리。결과표명，재효모균오니질량농도（MLSS）위5000 mg/L、외가탄원1.5 g/L、반응시간3 h적조건하，효모균예처리효과최가；당진수COD위1710 mg/L、취병희선알（PAM）위92 mg/L、함유74 mg/L시，처리계통대폐수COD、PAM급유적거제솔분별체도76.4%、95.0%、89.1%，중위립경은정재0.14μm，현부물강지1.2 mg/L；출수가체도SY/T 5329—2012중적삼투층주수표준。
To solve the reinjection problem of oilfield produced water from ASP flooding ,the process of a special kind of acid-producing yeast pretreatment combined with activated sludge hydrolysis acidification-membrane bioreactor,has been used for treating the produced water. The results show that when MLSS is 5 000 mg/L, additional carbon resources 1.5 g/L,and reaction time 3 h,the pretreatment result of the yeast is the best. The removing rates of COD,PAM and crude oil in wastewater by yeast-hydrolysis acidification-membrane bioreactor processes could be up to 76.4%,95.0%,and 89.1%,respectively,when influent COD 1 710 mg/L,PAM 92 mg/L, and crude oil 74 mg/L. The median particle diameter remains at 0.14μm and suspended solids content drops to 1.2 mg/L. The effluent can reach the permeable layer injection water standard in SY/T 5329—2012.
