实验流体力学
實驗流體力學
실험류체역학
JOURNAL OF EXPERIMENTS IN FLUID MECHANICS
2015年
2期
32-36
,共5页
符澄%彭强%张海洋%王超
符澄%彭彊%張海洋%王超
부징%팽강%장해양%왕초
结冰风洞%喷嘴%MVD%PDI%雾化
結冰風洞%噴嘴%MVD%PDI%霧化
결빙풍동%분취%MVD%PDI%무화
icing wind tunnel%spray nozzle%MVD%PDI%atomization
结冰风洞试验段中的云雾通常由安装在稳定段的喷雾系统产生。喷雾系统雾化喷嘴的性能直接关系到结冰风洞试验段平均水滴直径(MVD)、液态水含量以及云雾均匀性等关键技术指标。在喷嘴试验台上分别使用PDI(相位多普勒干涉仪)及微流量计对小粒径雾化喷嘴的平均水滴直径(MVD)及水流量进行测量,得到了结冰风洞空气辅助雾化喷嘴的流量-粒径性能包线,同时,对喷嘴的供水、供气压力及其配比和水路节流管尺寸对喷嘴雾化性能的影响进行了研究。研究结果表明:喷嘴水、气压力差的大小和范围决定了喷嘴的粒径及调节比的范围。压差越大,粒径和水流量越大,压力差范围越大,调节比越大。减小喷嘴水路节流管的直径,可以增加喷嘴工作的水、气压力差范围,扩展喷嘴的流量-粒径包络线。最终的测试结果表明,结冰风洞所使用喷嘴 MVD 范围为7~70μm,水流量调节比为11.5,其参数调节范围优于国外同类风洞所使用雾化喷嘴。
結冰風洞試驗段中的雲霧通常由安裝在穩定段的噴霧繫統產生。噴霧繫統霧化噴嘴的性能直接關繫到結冰風洞試驗段平均水滴直徑(MVD)、液態水含量以及雲霧均勻性等關鍵技術指標。在噴嘴試驗檯上分彆使用PDI(相位多普勒榦涉儀)及微流量計對小粒徑霧化噴嘴的平均水滴直徑(MVD)及水流量進行測量,得到瞭結冰風洞空氣輔助霧化噴嘴的流量-粒徑性能包線,同時,對噴嘴的供水、供氣壓力及其配比和水路節流管呎吋對噴嘴霧化性能的影響進行瞭研究。研究結果錶明:噴嘴水、氣壓力差的大小和範圍決定瞭噴嘴的粒徑及調節比的範圍。壓差越大,粒徑和水流量越大,壓力差範圍越大,調節比越大。減小噴嘴水路節流管的直徑,可以增加噴嘴工作的水、氣壓力差範圍,擴展噴嘴的流量-粒徑包絡線。最終的測試結果錶明,結冰風洞所使用噴嘴 MVD 範圍為7~70μm,水流量調節比為11.5,其參數調節範圍優于國外同類風洞所使用霧化噴嘴。
결빙풍동시험단중적운무통상유안장재은정단적분무계통산생。분무계통무화분취적성능직접관계도결빙풍동시험단평균수적직경(MVD)、액태수함량이급운무균균성등관건기술지표。재분취시험태상분별사용PDI(상위다보륵간섭의)급미류량계대소립경무화분취적평균수적직경(MVD)급수류량진행측량,득도료결빙풍동공기보조무화분취적류량-립경성능포선,동시,대분취적공수、공기압력급기배비화수로절류관척촌대분취무화성능적영향진행료연구。연구결과표명:분취수、기압력차적대소화범위결정료분취적립경급조절비적범위。압차월대,립경화수류량월대,압력차범위월대,조절비월대。감소분취수로절류관적직경,가이증가분취공작적수、기압력차범위,확전분취적류량-립경포락선。최종적측시결과표명,결빙풍동소사용분취 MVD 범위위7~70μm,수류량조절비위11.5,기삼수조절범위우우국외동류풍동소사용무화분취。
The icing cloud inside the icing wind tunnel test section is generated by the Spray Bar System (SBS)which is located at the wind tunnel settling chamber.The icing conditions such as the icing cloud liquid water content (LWC)and the water droplet size (MVD)are deter-mined by the spray nozzle performance of SBS.In this paper,the droplet size distribution and the water flux of the small droplet spray nozzle used in the icing wind tunnel are measured on a spray testing platform by Phase Doppler Interferometer(PDI)and low flow rate flow-meter.The for-ward scattering method was used to optimize the quality of the PDI signal and the reliability of the result.The influence of the water pressure,the air pressure,their difference and the throttle pipe diameter on the atomization characteristics of the spray nozzle are investigated.The results show that:when the pressure difference between water and air increases,the MVD and water flow-mass also increases;as the diameter of throttle pipe of water is reduced from 0.4mm to 0.35mm,the range of pressure difference between water and air increases,and the coverage of the water practical size and flow mass can exactly meet the icing wind tunnel operation require-ments.The water flow-mass ratio of the spray nozzle can reach 11.5 and the droplet diameter range can vary from 7μm to 70μm,which are better than the other similar icing wind tunnel spray nozzles in the world.