轴承
軸承
축승
BEARING
2015年
5期
38-40
,共3页
李文超%刘良勇%杨建虹%李彦%李庆喜
李文超%劉良勇%楊建虹%李彥%李慶喜
리문초%류량용%양건홍%리언%리경희
滚动轴承%高速轴承%过盈量%抗断油能力%试验
滾動軸承%高速軸承%過盈量%抗斷油能力%試驗
곤동축승%고속축승%과영량%항단유능력%시험
rolling bearing%high speed bearing%magnitude of interference%anti oil -interruption ability%test
从理论上分析了内圈与轴过盈量对轴承径向游隙的影响,并在内圈与轴不同过盈量情况下对 QJS207轴承进行了断油性能试验。结果表明:当轴承内圈与轴过盈量为0.014~0.015 mm 时,轴承可断油运转17~19 s;当内圈与轴过盈量为0.005~0.006 mm 时,轴承可断油运转30 s。
從理論上分析瞭內圈與軸過盈量對軸承徑嚮遊隙的影響,併在內圈與軸不同過盈量情況下對 QJS207軸承進行瞭斷油性能試驗。結果錶明:噹軸承內圈與軸過盈量為0.014~0.015 mm 時,軸承可斷油運轉17~19 s;噹內圈與軸過盈量為0.005~0.006 mm 時,軸承可斷油運轉30 s。
종이론상분석료내권여축과영량대축승경향유극적영향,병재내권여축불동과영량정황하대 QJS207축승진행료단유성능시험。결과표명:당축승내권여축과영량위0.014~0.015 mm 시,축승가단유운전17~19 s;당내권여축과영량위0.005~0.006 mm 시,축승가단유운전30 s。
The effects of magnitude of interference between inner ring and shaft on radial clearance of bearings is theo-retically analyzed,and the oil -interruption performance test for bearings QJS207 is carried out under different magni-tude of interference between inner ring and shaft.The results show that the bearings operate 1 7 ~1 9 s after oil -inter-ruption when magnitude of interference is 0.01 4 ~0.01 5 mm,30 s for 0.005 ~0.006 mm.