中华整形外科杂志
中華整形外科雜誌
중화정형외과잡지
CHINESE JOURNAL OF PLASTIC SURGERY
2015年
3期
209-214
,共6页
卢子敬%袁耀东%石岩%常强%高建华
盧子敬%袁耀東%石巖%常彊%高建華
로자경%원요동%석암%상강%고건화
组织工程%脂肪组织提取物%诱导组织再生%血管新生
組織工程%脂肪組織提取物%誘導組織再生%血管新生
조직공정%지방조직제취물%유도조직재생%혈관신생
Tissue engineering%Adipose tissue extract%Induction the tissue regeneration%Angiogenesis
目的 初步探讨组织工程室模型中脂肪组织提取物对血管和脂肪新生诱导的影响.方法 健康6个月龄新西兰大白兔64只,取兔腹股沟脂肪垫,经培养、离心、过滤后得到脂肪组织提取物(adipose tissue extract,ATE),应用组织工程室技术在兔背部左、右则建立2个组织工程室模型.1周后根据工程室内是否加入ATE分为2组:实验组为兔背部右侧工程室加入0.2 ml ATE,对照组为左侧加入等量生理盐水,注入后3d和1、2、3、4、7周取出标本,每个时间点8只,观察大体形态、体积,行HE染色,CD31检测.采用SPSS 13.0统计软件对每个时间点左、右两侧脂肪瓣的体积及毛细血管数目行配对£检验.结果 注入ATE后,实验组新生组织体积为(5.12±0.22) ml,较对照组的(4.90±0.15) ml明显增大,早期血管新生和数量明显增多,注入ATE后l周总的毛细血管的数量最高,并且实验组[(72.80±9.67)个]较对照组[(51.40±6.09)]个多,中期新生组织边缘更早出现血管周围的脂肪新生,后期新生组织最外层包膜厚度更薄,减少对内部脂肪新生的抑制,差异均有统计学意义(p<0.05).结论 ATE能促进组织工程室中脂肪和血管新生,同时减轻包膜挛缩对组织新生的抑制,诱导大体积脂肪组织再生.
目的 初步探討組織工程室模型中脂肪組織提取物對血管和脂肪新生誘導的影響.方法 健康6箇月齡新西蘭大白兔64隻,取兔腹股溝脂肪墊,經培養、離心、過濾後得到脂肪組織提取物(adipose tissue extract,ATE),應用組織工程室技術在兔揹部左、右則建立2箇組織工程室模型.1週後根據工程室內是否加入ATE分為2組:實驗組為兔揹部右側工程室加入0.2 ml ATE,對照組為左側加入等量生理鹽水,註入後3d和1、2、3、4、7週取齣標本,每箇時間點8隻,觀察大體形態、體積,行HE染色,CD31檢測.採用SPSS 13.0統計軟件對每箇時間點左、右兩側脂肪瓣的體積及毛細血管數目行配對£檢驗.結果 註入ATE後,實驗組新生組織體積為(5.12±0.22) ml,較對照組的(4.90±0.15) ml明顯增大,早期血管新生和數量明顯增多,註入ATE後l週總的毛細血管的數量最高,併且實驗組[(72.80±9.67)箇]較對照組[(51.40±6.09)]箇多,中期新生組織邊緣更早齣現血管週圍的脂肪新生,後期新生組織最外層包膜厚度更薄,減少對內部脂肪新生的抑製,差異均有統計學意義(p<0.05).結論 ATE能促進組織工程室中脂肪和血管新生,同時減輕包膜攣縮對組織新生的抑製,誘導大體積脂肪組織再生.
목적 초보탐토조직공정실모형중지방조직제취물대혈관화지방신생유도적영향.방법 건강6개월령신서란대백토64지,취토복고구지방점,경배양、리심、과려후득도지방조직제취물(adipose tissue extract,ATE),응용조직공정실기술재토배부좌、우칙건립2개조직공정실모형.1주후근거공정실내시부가입ATE분위2조:실험조위토배부우측공정실가입0.2 ml ATE,대조조위좌측가입등량생리염수,주입후3d화1、2、3、4、7주취출표본,매개시간점8지,관찰대체형태、체적,행HE염색,CD31검측.채용SPSS 13.0통계연건대매개시간점좌、우량측지방판적체적급모세혈관수목행배대£검험.결과 주입ATE후,실험조신생조직체적위(5.12±0.22) ml,교대조조적(4.90±0.15) ml명현증대,조기혈관신생화수량명현증다,주입ATE후l주총적모세혈관적수량최고,병차실험조[(72.80±9.67)개]교대조조[(51.40±6.09)]개다,중기신생조직변연경조출현혈관주위적지방신생,후기신생조직최외층포막후도경박,감소대내부지방신생적억제,차이균유통계학의의(p<0.05).결론 ATE능촉진조직공정실중지방화혈관신생,동시감경포막련축대조직신생적억제,유도대체적지방조직재생.
Objective To evaluate the influence of adipose tissue extract on inducing angiogenesis and adipogenesis in adipose tissue engineering chamber in vivo.Methods 6 months' healthy New Zealand rabbits(n =64) were picked.The inguinal fat pads were cultured,centrifuged,filtered,and the liquid was called adipose tissue extract (ATE).Two adipose tissue engineering chamber were built in the rabbit' s back.A week later,0.2 ml normal saline (control group,left) and 0.2 ml ATE (experimental group,right) was respectively injected into the chamber.The contents were evaluated morphometrically,histologically and immunohistochemically 3 days,1 week,2 weeks,3 weeks,4 weeks and 7 weeks after injection.8 rabbits were observed each time.The data regarding the number of the volume of fat flap and blood capillary at each time point were analyzed by paired t test.Results After injection,new tissue volume was significantly increased in the experimental group[(5.12 ± 0.22) ml],compared with that in control group [(4.90 ± 0.15) ml].Early angiogenesis was also increased after ATE injection and the total number of capillaries reached peak 1 week after injection,which was (72.80 ± 9.67) in experimental group and (51.40 ± 6.09) in control group.In the mid-term of experimental period,earlier adipogenesis appeared in experimental group.In the later period,the outer capsule of the new construction was thinner in experimental group which reduced the suppression of the adipogenesis.Conclusions ATE can promote the angiogenesis and adipogenesis in the chamber,and reduce the capsule contracturing,so as to induce the large volume of adipose tissue regeneration.