湿法冶金
濕法冶金
습법야금
HYDROMETALLURGY OF CHINA
2015年
3期
249-252
,共4页
张文娟%马莹%侯少春%李娜%包呈敏%李二斗
張文娟%馬瑩%侯少春%李娜%包呈敏%李二鬥
장문연%마형%후소춘%리나%포정민%리이두
聚苯乙烯树脂%稀土%皂化废水%油%去除
聚苯乙烯樹脂%稀土%皂化廢水%油%去除
취분을희수지%희토%조화폐수%유%거제
polystyrene resin%RE%saponification wastewater%oil%removal
研究了用聚苯乙烯树脂处理稀土皂化含油废水,考察了聚苯乙烯树脂对油的饱和吸附容量以及进水含油浓度、流速、处理时间和水量对油去除率的影响。结果表明:聚苯乙烯树脂对油的饱和吸附容量较高,约为91 mg/g ;树脂除油率随进水油浓度增大而降低,但对于油质量浓度为562.3 mg/L的稀土皂化废水,油去除率达87%以上;进水流速减小,油去除率增大;吸附平衡后,随处理时间延长和处理水量增加,油去除率急剧下降。
研究瞭用聚苯乙烯樹脂處理稀土皂化含油廢水,攷察瞭聚苯乙烯樹脂對油的飽和吸附容量以及進水含油濃度、流速、處理時間和水量對油去除率的影響。結果錶明:聚苯乙烯樹脂對油的飽和吸附容量較高,約為91 mg/g ;樹脂除油率隨進水油濃度增大而降低,但對于油質量濃度為562.3 mg/L的稀土皂化廢水,油去除率達87%以上;進水流速減小,油去除率增大;吸附平衡後,隨處理時間延長和處理水量增加,油去除率急劇下降。
연구료용취분을희수지처리희토조화함유폐수,고찰료취분을희수지대유적포화흡부용량이급진수함유농도、류속、처리시간화수량대유거제솔적영향。결과표명:취분을희수지대유적포화흡부용량교고,약위91 mg/g ;수지제유솔수진수유농도증대이강저,단대우유질량농도위562.3 mg/L적희토조화폐수,유거제솔체87%이상;진수류속감소,유거제솔증대;흡부평형후,수처리시간연장화처리수량증가,유거제솔급극하강。
In the paper ,using polystyrene resin to treatment oily wastewater in RE′s saponification was studied .The saturated absorption capacity for oil of polystyrene resin and the influence of oil concentration in the wastewater ,wastewater flow rate ,processing time and water quantity on removal of oil were examined .The results show that the saturated absorption capacity for oil of polystyrene resin is about 91 mg/g ,the removal of oil decreases with increasing oil concentration in the influent . However ,for the RE′s saponification wastewater which oil concentration is 562 .3 mg/L ,the removal rate of oil is more than 87% .The removal rate of oil increased when influent flow rate decreases .After adsorption equilibrium ,the removal rate of oil decreases sharply with extending processing time and increasing w ater quantity .