中国药师
中國藥師
중국약사
CHINA PHARMACIST
2015年
6期
901-903,904
,共4页
黄麦颗粒%制备工艺%淫羊藿苷%二苯乙烯苷
黃麥顆粒%製備工藝%淫羊藿苷%二苯乙烯苷
황맥과립%제비공예%음양곽감%이분을희감
Huangmai granules%Preparation process%Icariin%Stilbene glucoside
目的：：研究黄麦颗粒的制备工艺,确定最佳工艺条件。方法：采用单因素筛选法和正交设计法,进行提取工艺和成型工艺优选。结果：最佳工艺为处方量的7味药材,加8倍量水,煎煮2 h,提取3次,合并水提液,减压浓缩、干燥成干浸膏。干膏粉与适量糊精混合均匀后,加40%乙醇湿法制粒,干燥后整粒,即得。结论：所选工艺科学、合理、稳定,适合工业化生产。
目的：：研究黃麥顆粒的製備工藝,確定最佳工藝條件。方法：採用單因素篩選法和正交設計法,進行提取工藝和成型工藝優選。結果：最佳工藝為處方量的7味藥材,加8倍量水,煎煮2 h,提取3次,閤併水提液,減壓濃縮、榦燥成榦浸膏。榦膏粉與適量糊精混閤均勻後,加40%乙醇濕法製粒,榦燥後整粒,即得。結論：所選工藝科學、閤理、穩定,適閤工業化生產。
목적：：연구황맥과립적제비공예,학정최가공예조건。방법：채용단인소사선법화정교설계법,진행제취공예화성형공예우선。결과：최가공예위처방량적7미약재,가8배량수,전자2 h,제취3차,합병수제액,감압농축、간조성간침고。간고분여괄량호정혼합균균후,가40%을순습법제립,간조후정립,즉득。결론：소선공예과학、합리、은정,괄합공업화생산。
Objective: To determine the optimal preparation conditions for Huangmai granules. Methods: Using single factor screening method and orthogonal design method, the extraction process and granulation process were optimized. Results:The optimal preparation process was as follows:the medicinal materials in the prescription were extracted 3 times with 8-fold amount of water with 2h for each time. The water extract was combined followed by vacuum concentration, and then dried to obtain dry extract. The powder of dry extract was evenly mixed with dextrin at appropriate amount, and the wet granules were prepared with the 40% ethanol followed by drying and size stabilization to obtain the products. Conclusion:The selected preparation process is scientific, reasonable and sta-ble, and suitable for the industrial production.
