CAJ | 학술논문

针对工业上常用的变径悬臂搅拌轴，HG/T 20569中没有相应的临界转速计算方法，为找到简便的近似计算方法，使用ANSYS计算了3个算例的临界转速，并与HG/T 20569中悬臂与跨间二轴段直径相等、作用集中质量的悬臂轴的计算公式进行对比，经数据对比和理论分析，认为在计算变径悬臂搅拌轴的临界转速时，可以采用该公式，将变径轴的质量折算为当量质量来近似计算。
침대공업상상용적변경현비교반축，HG/T 20569중몰유상응적림계전속계산방법，위조도간편적근사계산방법，사용ANSYS계산료3개산례적림계전속，병여HG/T 20569중현비여과간이축단직경상등、작용집중질량적현비축적계산공식진행대비，경수거대비화이론분석，인위재계산변경현비교반축적림계전속시，가이채용해공식，장변경축적질량절산위당량질량래근사계산。
In HG/T 20569, there is no any method for calculation of critical rotating velocity for varied diameter cantilever shaft which is used widely in industries. In order to find approximate calculation method, three instances, all of which have equidiameters at cantilever and within span, were calculated for their critical rotating velocity by using ANSYS. The results then were compared with that resulted from the equations in HG/T20569. After the comparison, it was concluded that for varied diameter cantilever shaft, the critical rotating velocity can be calculated by using the equation provided in HG/T20569 only by converting the mass of varied diameter shaft into the equivalent mass of equidiameter shaft.