中国有色金属学报(英文版)
中國有色金屬學報(英文版)
중국유색금속학보(영문판)
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA
2015年
8期
2509-2515
,共7页
周堃%王彬%赵宇%刘杰
週堃%王彬%趙宇%劉傑
주곤%왕빈%조우%류걸
7A09 Al-Zn-Mg-Cu合金%晶间腐蚀%金属间化合物%电化学阻抗谱%极化
7A09 Al-Zn-Mg-Cu閤金%晶間腐蝕%金屬間化閤物%電化學阻抗譜%極化
7A09 Al-Zn-Mg-Cu합금%정간부식%금속간화합물%전화학조항보%겁화
7A09 Al-Zn-Mg-Cu alloy%intergranular corrosion%intermetallic particles%electrochemical impedance spectroscopy%polarization
采用扫描电镜、金相显微和电化学测试等综合评价技术研究7A09铝合金在3.5% NaCl(质量分数)水溶液中的腐蚀和电化学行为。结果表明:7A09铝合金不均一的显微组织结构导致该合金遭受严重的点蚀和晶间腐蚀,其中点蚀主要发生于金属间化合物或其周围,而沿晶界分布的阳极贫铜区的优先溶解是引起晶间腐蚀的主要原因。当不同浸泡时间时,在7A09铝合金表面交替进行着不同钝化膜的生成与溶解过程,并伴随着该合金钝化与去钝化行为的发生。同时,对该合金的腐蚀过程及机制进行分析。
採用掃描電鏡、金相顯微和電化學測試等綜閤評價技術研究7A09鋁閤金在3.5% NaCl(質量分數)水溶液中的腐蝕和電化學行為。結果錶明:7A09鋁閤金不均一的顯微組織結構導緻該閤金遭受嚴重的點蝕和晶間腐蝕,其中點蝕主要髮生于金屬間化閤物或其週圍,而沿晶界分佈的暘極貧銅區的優先溶解是引起晶間腐蝕的主要原因。噹不同浸泡時間時,在7A09鋁閤金錶麵交替進行著不同鈍化膜的生成與溶解過程,併伴隨著該閤金鈍化與去鈍化行為的髮生。同時,對該閤金的腐蝕過程及機製進行分析。
채용소묘전경、금상현미화전화학측시등종합평개기술연구7A09려합금재3.5% NaCl(질량분수)수용액중적부식화전화학행위。결과표명:7A09려합금불균일적현미조직결구도치해합금조수엄중적점식화정간부식,기중점식주요발생우금속간화합물혹기주위,이연정계분포적양겁빈동구적우선용해시인기정간부식적주요원인。당불동침포시간시,재7A09려합금표면교체진행착불동둔화막적생성여용해과정,병반수착해합금둔화여거둔화행위적발생。동시,대해합금적부식과정급궤제진행분석。
The corrosion and electrochemical behaviors of 7A09 Al?Zn?Mg?Cu alloy were investigated in 3.5% NaCl (mass fraction) solution using complementary techniques such as scanning electron microscopy (SEM), metallographic microscopy and electrochemical measurements. The results show that both pitting corrosion from or around the intermetallic particles and intergranular corrosion are observed after the immersion test due to the inhomogeneous nature of the microstructure of the 7A09 alloy. The preferential dissolution of the anodic Cu-depleted zone along grain boundaries is believed to be the possible cause of intergranular corrosion. The passivation and depassivation of this alloy show significant dependence of immersion time, owing to the formation and dissolution of various passive films on the sample surfaces. Furthermore, the corrosion process and corrosion mechanism were also analyzed.