激光技术
激光技術
격광기술
LASER TECHNOLOGY
2015年
5期
637-641
,共5页
非线性光学%纵模间隔%洛伦兹振子模型%材料色散
非線性光學%縱模間隔%洛倫玆振子模型%材料色散
비선성광학%종모간격%락륜자진자모형%재료색산
nonlinear optics%longitudinal mode interval%Lorentz oscillator mode%material dispersion
为了分析材料色散对法布里-珀罗干涉仪透射特性的影响,采用洛伦兹振子模型计算了法布里-珀罗干涉仪的透射谱,研究了色散强度、衰减系数和谐振频率对纵模间隔的影响。结果表明,高、低频段的纵模间隔随色散强度的增大而减小,随衰减系数的增大而增大;对于谐振频率附近的纵模,纵模间隔随着色散强度的增大先增大后减小;色散强度很小时,纵模间隔随衰减系数的增大而减小,随谐振频率的增大先增大后减小;当色散强度较大时,纵模间隔随衰减系数的增大先增大后减小,随谐振频率的增大而减小。这一结果对激光器的设计和研究有一定的帮助。
為瞭分析材料色散對法佈裏-珀囉榦涉儀透射特性的影響,採用洛倫玆振子模型計算瞭法佈裏-珀囉榦涉儀的透射譜,研究瞭色散彊度、衰減繫數和諧振頻率對縱模間隔的影響。結果錶明,高、低頻段的縱模間隔隨色散彊度的增大而減小,隨衰減繫數的增大而增大;對于諧振頻率附近的縱模,縱模間隔隨著色散彊度的增大先增大後減小;色散彊度很小時,縱模間隔隨衰減繫數的增大而減小,隨諧振頻率的增大先增大後減小;噹色散彊度較大時,縱模間隔隨衰減繫數的增大先增大後減小,隨諧振頻率的增大而減小。這一結果對激光器的設計和研究有一定的幫助。
위료분석재료색산대법포리-박라간섭의투사특성적영향,채용락륜자진자모형계산료법포리-박라간섭의적투사보,연구료색산강도、쇠감계수화해진빈솔대종모간격적영향。결과표명,고、저빈단적종모간격수색산강도적증대이감소,수쇠감계수적증대이증대;대우해진빈솔부근적종모,종모간격수착색산강도적증대선증대후감소;색산강도흔소시,종모간격수쇠감계수적증대이감소,수해진빈솔적증대선증대후감소;당색산강도교대시,종모간격수쇠감계수적증대선증대후감소,수해진빈솔적증대이감소。저일결과대격광기적설계화연구유일정적방조。
In order to study effect of material dispersion on transmission characteristics of a Fabry -Perot interferometer ( F-PI) , transmission spectrum of the F-PI was calculated based on the Lorentz oscillator mode and the effect of dispersion intensityχ0 , attenuation coefficient γand resonant frequency ω0 on longitudinal mode interval was investigated .The results show that the interval between longitudinal modes at low and high frequency band decreases with the increasing of χ0 and increases with the increase of γ.For the longitudinal modes near ω0 , the interval between longitudinal modes increases with the increase of χ0 at first and then decreases .Whenχ0 is small, the interval between longitudinal modes decreases with the increase of γand increases with the increase of ω0 at first and then decreases when χ0 is big, the interval between longitudinal modes increases with the increase ofγat first and then decreases , and decreases with the increase of ω0 .The results are helpful for design and research of lasers.