工业水处理
工業水處理
공업수처리
INDUSTRIAL WATER TREATMENT
2015年
7期
65-67
,共3页
乳化废水%EF-H2O2-FeOx-絮凝%废水处理
乳化廢水%EF-H2O2-FeOx-絮凝%廢水處理
유화폐수%EF-H2O2-FeOx-서응%폐수처리
emulsion wastewater%EF-H2O2-FeOx-flocculation%wastewater treatment
采用EF-H2O2-FeOx—絮凝处理含油乳化废水。结果表明，电解电压8 V，pH=2.5，电解反应时间75 min， PAM投加质量浓度为2 mg/L时，对含油乳化废水的处理效果最佳，COD的去除率最高可达93%以上。此方法具有高效、去除效果好、经济适用等优点，在含油废水的处理领域具有广阔的应用前景。
採用EF-H2O2-FeOx—絮凝處理含油乳化廢水。結果錶明，電解電壓8 V，pH=2.5，電解反應時間75 min， PAM投加質量濃度為2 mg/L時，對含油乳化廢水的處理效果最佳，COD的去除率最高可達93%以上。此方法具有高效、去除效果好、經濟適用等優點，在含油廢水的處理領域具有廣闊的應用前景。
채용EF-H2O2-FeOx—서응처리함유유화폐수。결과표명，전해전압8 V，pH=2.5，전해반응시간75 min， PAM투가질량농도위2 mg/L시，대함유유화폐수적처리효과최가，COD적거제솔최고가체93%이상。차방법구유고효、거제효과호、경제괄용등우점，재함유폐수적처리영역구유엄활적응용전경。
EF-H2O2-FeOx-flocculation process has been used for the treatment of oil-bearing emulsion wastewater. The results indicate that when electrolytic voltage is 8 V,pH 2.5,reaction time 75 min,and PAM dosage 2 mg/L,the treatment effect on oil-bearing emulsion wastewater is the best. The highest COD removing rate can be higher than 93%. The method has the advantages of high efficiency,good removing effect,and is economic and functional. As a result,it has wide application prospect in the field of oil-bearing emulsion wastewater treatment.
